Advantech HMI-640S user manual Networking Communication

Page 8

4.12	Card installation	56
4.13	Card removal	57
4.14	FPC cable installation	58
Chapter 5 CPC-2520 VGA/LCD Control Board		59
5.1	Introduction	60
5.2	Specifications	61
	General	61
	Mechanical and environmental	61
5.3	Board layout: dimensions	62
5.4	Jumpers and connectors	63
5.5	Board layout: jumper/connector locations	64
5.6	Safety precautions	65
5.7	Jumper settings	66
5.8	LCD panel select (SW1)	67
5.9	Display connectors (CN2, CN3)	67
5.10	LCD display connector (CN2)	68
5.11	VGA display connector (CN3)	69
5.12	FPC cable installation	71
Chapter 6 Networking Communication		73
6.1	Introduction	74
6.2	Networking via LAN	74
6.2	Networking via RS-232	76
6.3	Simple Networking via a Hub	77
Chapter A Cabling for RS-232 Port		79
Chapter B DIP Switch Settings		83
B.1	Touchscreen Specifications	84

Image 8

Contents HMI-640S Copyright notice Acknowledgments FCC Class a notes Safety Instructions Wichtige Sicherheishinweise Contents Maintenance Networking Communication Figures Page General Information Specifications IntroductionGeneral Standard functions CPC-2245NPS/2 keyboard/mouse connector Mini-DIN keyboard connector Power supply Environmental specificationsEthernet interface SVGA/Flat panel interface CPC-2520LCD Specifications TouchscreenCOM2 port settings I/O ArrangementTotal Solution Dimensions Mounting Page System Setup General Packing ListInitial Setup Installing a CompactFlash Memory Card Installing a CompactFlash adapterInstalling a 2.5 HDD Connecting the Power Adapter Installing a PC/104 Module PC/104 module dimensions mm ±5 % Assign the Device Name First System BootPower up for the first time Exploded Diagram Maintenance Removing the Front/Rear Panel Maintenance LCD Display LCD Backlight Power Supply I/O Adapter CPC-2900 Core of HMI-640S CPC-2520/CPC-2245N/ CPC-2430 CPC-2245N Main Board Introduction ISA/IDE/FDD/parallel port 144-pin Sodimm socket Super I/O chipset Winbond W83977FVGA/LAN/serial port/keyboard/mouse 40-pin FPC connector Mechanical and environmentalBoard layout dimensions Jumpers and connectors Name FunctionBoard layout jumper/connector locations Board layout jumper/connector locationsSafety precautions Setting jumpers CompactFlash interface CN2 Clear Cmos J2ISA/IDE/floppy drive/parallel port CN3 Pin Signal Bus SA0 ISA ISA bus CN3GND Rstdrv IRQ9 DRQ2 Memw MEMCS16 Pin Signal IDE interfaceDamping resistor Floppy drive Parallel port 10 VGA/LAN/serial ports/keyboard/ mouse CN4 VGA interface Ethernet configuration Keyboard and PS/2 mouse connectorSerial ports Port Address Default Power supply connector CN5 Card installation Card removal FPC cable installation CPC-2520 VGA/LCD Control Board Introduction Display output Board layout dimensions Number Function Board layout jumper/connector locations Safety precautions Jumper settings Display connectors CN2, CN3 LCD panel select SW1LCD display connector CN2 VGA display connector CN3 Model number of the CN3 socket isVGA CN3 FPC cable installation Page Networking Communica- tion Networking via LAN Connect or disconnect any cableTo assign the IP addresses to your machines, just RAS service, you must install it on your system Networking via RS-232Simple Networking via a Hub Page Cabling for RS-232 Port Pin Null Modem Cable Clear to Send Page DIP Switch Settings Touchscreen Specifications