Advantech user manual Hard Drive installation UNO-1170E

Page 35

3.6 Hard Drive installation (UNO-1170E)

The procedure for installing a hard drive into the UNO-1170E is shown as following step.

1.Remove the power.

2.Unscrew six screws from UNO-1170E indicated below.

3.Remove the rear cover. Please refer to Section 3.1 & 3.2 for the instruction to open the cover.

4.Take four screws from the rear cover to lose the hard drive bracket.

5.Connect the SATA cable and SATA power cable. Make sure the cable will not lose. Use the screws in accessory to mount the hard drive on the hard drive bracket.

27

Image 35

Contents UNO-1170/1170E Copyright Notice Acknowledgements Product Warranty 2 years Packing List FCC Class aTechnical Support and Assistance Safety Instructions Safety Precaution Static Electricity Contents Appendix Programming the Watchdog Timer UNO-1170 Overview Introduction Hardware SpecificationsRelative humidity 95% @ 40C Safety PrecautionsUNO-1170 Series Chassis DimensionsUNO-1170E Chassis Dimensions Page Hardware Functionality UNO-1170 Front View UNO-1170 PeripheralsUNO-1170E Front View COM3 RS-232/422/485 Interfaces COM1~COM2 RS-232 Interfaces4 RS-232/422/485 Selection Jumper Setting for RS-422/485 Interface Default SettingTerminal Resistor Setup for RS-422/485 Power Connector LAN Ethernet ConnectorVGA VGA Display Connector LED IndicatorsPS/2 Keyboard and Mouse Connector Universal Serial Bus ConnectorsLED and Buzzer for System Diagnosis Reset Reset ButtonBattery Backup Sram AudioProgrammable LED Control Bit RS-422/485 Jumper Settings 14 PCI/104+ Connectors UNO-1170E onlyPage Initial Setup CompactFlash Card Installation Page USB Keypro and Keypro Bracket Installation Chassis Grounding Power ConnectionPC/104+ Card Installation UNO-1170E Page Page Hard Drive installation UNO-1170E Page DIN-rail Mounting Setup Bios Setup and System AssignmentsWallmounting Setup System Settings and Pin Assignments System I/O Address & Interrupt Assignments Appendix a System Settings and Pin AssignmentsTable A.2 UNO-1170 Interrupt Assignment Figure A.1 Connector & Jumper Locations Top Board Connectors and JumpersTable A.3 Connectors & Jumpers Table A.4 Connectors & Jumpers UNO-1170E RS-232 Serial Port COM1~COM2 RS-232/422/485 Serial Port COM3 Ethernet RJ-45 Connector LAN1~LAN2PS/2 Keyboard and Mouse Connector CN10 Power Screw Terminal CN8Display Memory USB Connector CN13VGA Display Connector CN15 Sata Data Connector CN17 Page Programming the Watchdog Timer Appendix B Programming the Watchdog Timer