Table 2.4: Auto Flow & Slave/Master Selection
| SW2 DIP Switch Setting | COM Port | Mode Selections |
| | | | | | | |
| | | | | | COM2 | RS-422: Slave mode |
| | 1 | | O | | |
| | | | RS-485: Auto flow control |
| | | | |
| | 2 | | N | | | |
| | COM3 | RS-422: Slave mode |
| | | | |
| | | | | | |
| | | | | | |
| | | | | | RS-485: Auto flow control |
| | | | | |
| | | | | | |
| | | | | | | |
| | | | | | COM2 | RS-422: Master mode |
| | 1 | | O | | |
| | | | RS-485: N/A |
| | | | |
| | 2 | | N | | | |
| | COM3 | RS-422: Slave mode |
| | | | |
| | | | | | |
| | | | | | |
| | | | | | RS-485: Auto flow control |
| | | | | |
| | | | | | |
| | | | | | | |
| | | | | | COM2 | RS-422: Slave mode |
| | 1 | | O | |
| | | | |
| RS-485: Auto flow control |
| | 2 | | N | | |
| | | | |
| | | | | COM3 | RS-422: Master mode |
| | | | |
| | | | | | RS-485: N/A |
| | | | | | |
| | | | | | | |
| | | | | | COM2 | RS-422: Master mode |
| | 1 | | O | |
| | | | |
| RS-485: N/A |
| | 2 | | N | | |
| | | | |
| | | | | COM3 | RS-422: Master mode |
| | | | |
| | | | | | RS-485: N/A |
| | | | | | |
| | | | | | | |
2.4 LAN: Ethernet Connector
The UNO-1170 is equipped with two Realtek RTL8100CL Ethernet LAN controllers that are fully compliant with IEEE 802.3u 10/100Base-T CSMA/CD standards. The Ethernet port provides a standard RJ-45 jack onboard, and LED indicators on the front side to show its Link (Yellow LED) and Active (Green LED) status. Please refer to A.4 for its pin assignments.
2.5 Power Connector
The UNO-1170 comes with a Phoenix connector that carries 10~36 VDC external power input, and has reversed wiring protection. Therefore, it will not cause any damage to the system by reversed wiring of ground line and power line. Please refer to A.5 for its pin assignments.