Advantech UNO-1170E user manual

Page 36

6.Turn the hard drive bracket and align with the screw hole on the rear cover. Use the four screws taken from step 4 and screw the bracket and the rear cover tight.

7.Connect the other end of SATA cable on the board which the arrow indicated in below picture.

8.Screw the rear cover and the six screws.

9.For user who tried to plug other SATA device, please note the UNO-1150E SATA power connector doesn't support 12V power.

Note: There are switch setting about SATA hard drive below, please refer to the section A.9 for detail. The hard drive might not work correctly if the switch setting is incorrect

UNO-1170 User Manual

28

Image 36
Contents UNO-1170/1170E Copyright Notice Acknowledgements Product Warranty 2 years FCC Class a Technical Support and AssistancePacking List Safety Instructions Safety Precaution Static Electricity Contents Appendix Programming the Watchdog Timer UNO-1170 Overview Hardware Specifications IntroductionSafety Precautions Relative humidity 95% @ 40CChassis Dimensions UNO-1170 SeriesUNO-1170E Chassis Dimensions Page Hardware Functionality UNO-1170 Peripherals UNO-1170 Front ViewUNO-1170E Front View COM1~COM2 RS-232 Interfaces COM3 RS-232/422/485 InterfacesJumper Setting for RS-422/485 Interface Default Setting 4 RS-232/422/485 SelectionTerminal Resistor Setup for RS-422/485 LAN Ethernet Connector Power ConnectorLED Indicators PS/2 Keyboard and Mouse ConnectorUniversal Serial Bus Connectors VGA VGA Display ConnectorReset Reset Button Battery Backup SramAudio LED and Buzzer for System DiagnosisProgrammable LED Control Bit 14 PCI/104+ Connectors UNO-1170E only RS-422/485 Jumper SettingsPage Initial Setup CompactFlash Card Installation Page USB Keypro and Keypro Bracket Installation Power Connection Chassis GroundingPC/104+ Card Installation UNO-1170E Page Page Hard Drive installation UNO-1170E Page Bios Setup and System Assignments DIN-rail Mounting SetupWallmounting Setup System Settings and Pin Assignments Appendix a System Settings and Pin Assignments System I/O Address & Interrupt AssignmentsTable A.2 UNO-1170 Interrupt Assignment Board Connectors and Jumpers Figure A.1 Connector & Jumper Locations TopTable A.3 Connectors & Jumpers Table A.4 Connectors & Jumpers UNO-1170E RS-232 Serial Port COM1~COM2 Ethernet RJ-45 Connector LAN1~LAN2 RS-232/422/485 Serial Port COM3Power Screw Terminal CN8 PS/2 Keyboard and Mouse Connector CN10USB Connector CN13 VGA Display Connector CN15Display Memory Sata Data Connector CN17 Page Programming the Watchdog Timer Appendix B Programming the Watchdog Timer