Epson 610 manual Error Indications, Command Error

EPSON Perfection 610 Revision B

1.6 Error Indications

Refer to Section 1.5 for the error indications.

COMMAND ERROR

￿Cause:		Undefined command is detected.
Disposition:		The scanner ignores a wrong command and
		parameter(s), so it keeps the current settings or
		default value effective. The scanner sends
		NACK and waits for the next command and
		parameter(s).
￿Indicator:		No effect
Remedy:		Error condition is cleared when the scanner
		receives a correct command.
COMMUNICATION￿		ERROR
Cause:		Wrong procedure is detected in the interface
		communication.
		USB cable was removed during communication.
Disposition:		The scanner stops the ongoing job.
Indicator:		The lamp starts blinking. (The lamp goes off in
		30 minutes.)
Remedy:		Turn the scanner off and then back on.
￿		Connect the USB cable again.
Acceptable command: None
FATAL￿	ERROR
Cause:		The lamp is broken.
		The scanner is turned on before the
		transportation lock is released.
￿		System breakdown
Disposition:		The scanner stops the ongoing job.

￿Indicator:	The lamp starts blinking. (The lamp goes off after
	30 minutes.)
	The lamp does not light up when it has blown.
Remedy:	(After the cause of the error is removed)
	Turn the scanner off and then back on.
	Connect the USB cable again.
￿	Receiving of ESC@

Acceptable command: [ESC F, ESC f, ESC @]

Product Description Error Indications 13