Metrologic Instruments MS6130, MX003 manual Changing the ID, Handset /X

Page 21

CHANGING THE ID

In order for the MS6130 to send data to the correct receiver, they must have a matching ID number. The ID number is the serial number of the receiver. When the matching procedure is completed, the receiver will accept data only from a MS6130 that has the matching ID number. Each receiver is programmed with its serial number before it leaves the factory.

1.To program a new ID for the receiver, HANDSET

(Version 1.14 or greater) must be used. Type the following at the DOS prompt:

HANDSET /X

2.Power up the receiver, but DO NOT scan any bar codes.

3.Select “Enter Program Mode”. Select the appropriate SERIAL PORT (COM 1 or COM 2) on the PC. Make sure the Receiver is connected to the SERIAL PORT selected.

4.Select “Get Scanners Settings”. A screen will appear showing all of the options available.

5.Using the arrow keys, move down to the section labeled “Metro ID#”. Locate the serial number on the case of the receiver. Enter this 10- digit number into the “Metro ID#” section.

6.Press the “F5" key to program the receiver.

7.The receiver will beep when programming is completed. The receiver is now programmed with its proper ID. Exit HANDSET by pressing “F9" and then press “7".

8.Power Down the receiver.

17

Image 21
Contents Metrologic INSTRUMENTS, INC Locations Table of Contents Table of Contents MS6130 Hand Held BAR Code Scanner MX003 Series Scanner Interfaces Unpacking List Transmitter GroupReceiver Group Except version Connections of the Mxnterfacei to the Host DeviceVersion 17 only Connections of the Keyboard Wedge Mxnterfacei to the PCConnections of the MS700I/MS720I With Mxto the Host Device Configuration of the MS700I/MS720I with MX Page Configuration of the Mxto the Scanpal Data Collector Page KB Parameter Keyboard Type Keyboard Wedge KB InterfaceKB Parameter Keyboard Type KB Parameter Caps Lock Mode Microsecond Delay KB Parameter Alt ModeMillisecond Delay Millisecond Delay KB Parameter XT Clean-Up BitConfiguration of the MS6130 HAND-HELD Enabling the MS700I/MS720I SCANNER’S RF LOW Speed Option Handset /X Changing the IDMatching Procedure Output Window Parts of the MS6130 HAND-HELD BAR Code ScannerComponents of the MS6130 Series Stand Installation of the MS6130 Series Stand Permanent Counter TOP Installation Installation of the 6000 Series Universal Charging StandRecommended USE Nicd Battery Charger with Reconditioning FeatureVisual Indicators One Beep Audible IndicatorsRazzberry Tone Two BeepsAudible Indicators Labels MaintenanceTroubleshooting Appendix a SpecificationsMX003 Series Scanner Interface Specifications Temperature Characteristics Degrees Celsius of each Cell Appendix B Default Settings of the MS6130 and MX ReceiverRTS/CTS UPC EAN Parameter Transmitter Default Keyboard Receiver Wedge Appendix C MX003 Series Scanner Interface Pin AssignmentsPin Function Appendix D Warranty and DisclaimerAppendix E Patents Appendix FESD IndexTroubleshooting