Metrologic Instruments MX003 Connections of the Mxnterfacei to the Host Device, Except version

Page 8

CONNECTIONS OF THE “MX”NTERFACEI TO THE HOST DEVICE

Except version 17

1.Turn off the host system.

2.Connect the MCA to the host device. Connect the “MX” interface to the MCA.

3.Check the AC input requirements of the transformer to make sure the voltage matches the AC outlet. The socket outlet should be near the equipment and easily accessible.

4.Plug the transformer into the side of the MCA and the AC outlet.

5.Power up the host system.

MS6130 with Liberty® RF

Transformer

Scanner Interface

(Transmitter)

 

 

 

 

 

 

“MX” Scanner Interface

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

MCA

Host System

Figure 2: Connecting the “MX” (through the MCA) to a host device

To maintain compliance with applicable standards, all circuits connected to the unit must meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.

4

Image 8
Contents Metrologic INSTRUMENTS, INC Locations Table of Contents Table of Contents MS6130 Hand Held BAR Code Scanner MX003 Series Scanner Interfaces Receiver Group Unpacking ListTransmitter Group Connections of the Mxnterfacei to the Host Device Except versionConnections of the Keyboard Wedge Mxnterfacei to the PC Version 17 onlyConnections of the MS700I/MS720I With Mxto the Host Device Configuration of the MS700I/MS720I with MX Page Configuration of the Mxto the Scanpal Data Collector Page Keyboard Wedge KB Interface KB Parameter Keyboard TypeKB Parameter Keyboard Type KB Parameter Caps Lock Mode KB Parameter Alt Mode Microsecond DelayMillisecond Delay Millisecond Delay KB Parameter XT Clean-Up BitConfiguration of the MS6130 HAND-HELD Enabling the MS700I/MS720I SCANNER’S RF LOW Speed Option Changing the ID Handset /XMatching Procedure Parts of the MS6130 HAND-HELD BAR Code Scanner Output WindowComponents of the MS6130 Series Stand Installation of the MS6130 Series Stand Installation of the 6000 Series Universal Charging Stand Permanent Counter TOP InstallationNicd Battery Charger with Reconditioning Feature Recommended USEVisual Indicators Audible Indicators One BeepRazzberry Tone Two BeepsAudible Indicators Maintenance LabelsTroubleshooting Specifications Appendix aMX003 Series Scanner Interface Specifications Temperature Characteristics Degrees Celsius of each Cell Default Settings of the MS6130 and MX Receiver Appendix BRTS/CTS UPC EAN Parameter Transmitter Default Keyboard Receiver Wedge Pin Function Appendix CMX003 Series Scanner Interface Pin Assignments Warranty and Disclaimer Appendix DAppendix E Appendix F PatentsIndex ESDTroubleshooting