Metrologic Instruments MX003, MS6130 manual Appendix E

Page 42

APPENDIX E

Notices

Notice - applicable to 912 MHZ devices only

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any unauthorized changes or modifications to this equipment could void the users authority to operate this device.

Notice - applicable to 912 MHZ devices when used in Canada

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Caution

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous laser light. Under no circumstances should the customer attempt to service the laser scanner. Never attempt to look at the laser beam, even if the scanner appears to be nonfunctional. Never open the scanner in an attempt to look into the device. Doing so could result in hazardous laser light exposure. The use of optical instruments with the laser equipment will increase eye hazard.

38

Image 42

Contents Metrologic INSTRUMENTS, INC Locations Table of Contents Table of Contents MS6130 Hand Held BAR Code Scanner MX003 Series Scanner Interfaces Unpacking List Transmitter GroupReceiver Group Connections of the Mxnterfacei to the Host Device Except versionConnections of the Keyboard Wedge Mxnterfacei to the PC Version 17 onlyConnections of the MS700I/MS720I With Mxto the Host Device Configuration of the MS700I/MS720I with MX Page Configuration of the Mxto the Scanpal Data Collector Page Keyboard Wedge KB Interface KB Parameter Keyboard TypeKB Parameter Keyboard Type KB Parameter Caps Lock Mode Millisecond Delay KB Parameter Alt ModeMicrosecond Delay Millisecond Delay KB Parameter XT Clean-Up BitConfiguration of the MS6130 HAND-HELD Enabling the MS700I/MS720I SCANNER’S RF LOW Speed Option Changing the ID Handset /XMatching Procedure Parts of the MS6130 HAND-HELD BAR Code Scanner Output WindowComponents of the MS6130 Series Stand Installation of the MS6130 Series Stand Installation of the 6000 Series Universal Charging Stand Permanent Counter TOP InstallationNicd Battery Charger with Reconditioning Feature Recommended USEVisual Indicators Razzberry Tone Audible IndicatorsOne Beep Two BeepsAudible Indicators Maintenance LabelsTroubleshooting Specifications Appendix aMX003 Series Scanner Interface Specifications Temperature Characteristics Degrees Celsius of each Cell Default Settings of the MS6130 and MX Receiver Appendix BRTS/CTS UPC EAN Parameter Transmitter Default Keyboard Receiver Wedge Appendix C MX003 Series Scanner Interface Pin AssignmentsPin Function Warranty and Disclaimer Appendix DAppendix E Appendix F PatentsIndex ESDTroubleshooting