5.Peel off the black tape near the DIMM slot to expose the SW1 dip switch.
6.Locate the SW1 dip switch (G55).
7.Position the SWI dip switch to ON to clear all system passwords.
8.Reinstall the memory modules and the lower case cover.
9.Turn on the computer and press F2 during bootup to access the Setup Utility.
10.Press F9 to load the system defaults.
11.Press F10 to save the changes you made and close the Setup Utility.
Boot
The Boot menu screen allows users to set the drive sequence in which Setup attempts to boot the operating system. By default, Setup searches for boot devices in the order shown in the screen below.
To set the boot drive sequence:
1.Press 
or 
to select a bootable device.
2.Press F6 to move the device up the list, or F5 to move it down the list.
3.Press F10 to save the changes you made and close the Setup Utility.
Chapter 1 | 19 |