To change a system password:
1.Press 
or 
to highlight an enabled password field, then press Enter. The password box appears.
2.Type the original password, then press Enter.
3.Type a new password, then press Enter.
4.Retype the new password to verify the first entry, then press Enter. You will be prompted to save the new password.
5.Press Enter.
6.Press F10 to save the password and close the Setup Utility.
To remove a system password:
1.Press 
or 
to highlight a password parameter, then press Enter. The password box appears.
2.Type the original password, then press Enter.
3.Press Enter twice without entering anything in the new and confirm password fields. You will be prompted to confirm the password removal.
4.Press Enter.
The corresponding password status field displays Clear to indicate that the password has been disabled.
5.Press F10 to save the changes you made and close the Setup Utility.
To clear a lost password:
If you have forgotten the user password, the computer will continue to function normally but you will have limited access to the Setup Utility.
If you have enabled the Password on Boot field and you forget the supervisor password, you will not be able to boot up the computer. The same thing applies if you forget an HDD password. You will need to clear the lost password by shorting the SW1 dip switch located near the DIMM slot (DM1).
Perform the following procedure to clear all the system passwords (user, supervisor, and HDD).
1.Turn off the computer and unplug all the peripherals connected to it.
2.Unplug the power cord from the computer.
3.Remove the lower case cover according to the instructions described on page 28.
4.Remove the memory modules according to the instructions described on page 29.
18 | Chapter 1 |