Acer ASX1200, ASX3200 manual Per Channel, Minimim

DRAM Configuration

Parameter	Description	Option
Timing Mode	When set to auto mode, the system reads the electronic data sheet of the	Auto
	memory modules and adjusts the timings accordingly.	MaxMemClk
	When set to MaxMemClk, you can manually specify the memory clock
	frequency independent of the system bus frequency.
Memory Clock value or Limit	Displays the current memory clock frequency.
CKE base power down	All synchronous memory devices can go into sleep mode as soon as the	Disabled
mode	clock enable (CKE) signal is disasserted. In that case, the internal clocks are	Enabled
	disabled and the memory chip goes into auto-refresh mode which is the
	lowest power state at which the memory retains data.
	If then power is turned off, the device will lose all data, however, as long as
	standby power is maintained, no data loss will occur.
CKE based power down	Sets the CKE power saving through disasserting clock enable using system	Per Channel
	level or per channel basis.	Per CS
Memclock tri-stating	Enables or disables the memory clock tri-stating during C3 an Alt VD	Disabled
	feature.	Memclock tri-
		stating during
		C3 and Alt VD
Memory Hole Remapping	Enables or disables memory remapping around the memory hole.	Enabled
		Disabled
Auto Optimize Bottom IO	Allows you to auto optimize maximal memory size when kernel assigns PCI	Enabled
	Resources.	Disabled
Bottom of UMA DRAM	Allows you to enter a HEX number ranging from 0000 to 00F0.	Minimim 0000
[31:24] [FC]		Maximum 00FC

Chapter 2 17