Siemens eWON4002 manual Recommendations for the GSM/GPRS antenna, SIM-card insertion

Page 15

eWON4002™

Installation Guide

ver 2 . 04

5.3.1 Recommendations for the GSM/GPRS antenna

A dual band GSM/GPRS antenna is available as accessory (ref EW40902). Here are our recommendations for GSM antenna:

Specification

Value

 

 

Description

GSM/DCS gain GSM antenna

Dual band 900/1800 MHz

 

 

 

Gain dB

+2 dB @ 900 MHz

+0 dB @ 1800 MHz

 

 

 

Max antenna cable length

5m

(recommended)

 

Antenna cable termination required

SMA-M

Warning: adapter SMA-M/FME-M to be inserted if antenna has

to be compatible with the eWON®

FME-F termination (available as spare)

 

 

 

Table 8: Recommendations for GSM/GPRS antenna

Eject SIM card

SIM card drawer

SMA antenna

connector’s place

button

 

 

 

Figure 8: SIM-card insertion

 

page 12 of 35

Image 15
Contents Installation Guide EWON4002 Installation Guide Table Of Contents IP parameters configuration Technical support Ethernet Gateway General specification of the hardware platformProduct description IntroductionPart Numbers and internal options RAS Modem & PIRDatalogger Typical applicationsType/Description Part Number External accessoriesCc= Communication Xy = OptionsStructure of the eWON technical documentation Level Title ContentsHousing Housing and markingsSerial number Required power supplyMarkings Applicable directives, standards and complianceMechanical outline Equipment information and versionsSpring Bottom Slider Mounting and environmental conditionsAuto fuse Preparing the installationSpecifications for external power supply selection Specification ValueFront panel control LEDs Ethernet Port Communication interfaces and I/OsEmbedded Pstn Modem Embedded GSM/GPRS ModemSIM-card insertion Recommendations for the GSM/GPRS antennaSerial port Dip switch Serial portsSerial port #1 Serial port #2 Positions ModeSerial port #3 Serial port 3 connector and dip switchDigital Inputs Open collector Digital Output Digital OutputsConfigurable standard Analog Inputs AI1 AI4 Analog InputsRelays Resistive Temperature Detector Inputs Under Windows 98, NT Communicating with the eWONBy Ethernet By phone line or GSMUnder Windows XP EWONCFG utility and IP parameter window IP parameters configurationTechnical support ResetsUser Reset Factory ResetPower supply Connector Appendix Pinouts and connections Power SupplyCrossed Cable Ethernet ConnectorEthernet Direct connectionHub/Router Straight Cable Connection over hub/routerRJ 45 connector/cabling RJ45 connectorDigital Input/Output connector pinout Pin Description 1 DI / do connectorDigital Input/Output Connector Digital Input/Output mating female connector includedAnalog Input Analog Input ConnectorAnalog Input mating female connector included Analog Input connector pinout Pin DescriptionRelays output Relay ConnectorRelays Output mating female connector included Relays output connector pinout Pin DescriptionDigital Input Digital inputTop face Back face Front FaceSerial ports connectors Female DB9 with 4/40 blocking screws Pin RS232 Pinout serial ports 1 and 3 according to modePinout serial port Pin RS232 RS485 RS422DA is connected to B- and DB is connected to A+ MiniDIN PIN Schneider Signal EWON Signal Name EWON SUBDB9Connector Unitelway/Modbus serial cablePstn phone line connector Pstn phone line ConnectorPstn phone line mating male connector not included