Siemens eWON4002 manual Serial port #2, Positions Mode

Page 17

eWON4002™

Installation Guide

ver 2 . 04

Positions

Mode

 

 

OFF

RS232

 

ON

 

 

 

OFF

RS422, RS485

 

 

WITHOUT polarisation and termination resistors

ON

 

 

 

OFF

RS422, RS485

 

 

WITH polarisation and termination resistors

ON

 

Table 10: Serial mode configuration switches

Note: the 3 switch configurations shown in the table above are the only configurations giving satisfactory results.

Warning: The switch 2 is reserved and must stay OFF. Note that the switches 3 & 4 need to have the same position (both ON or both OFF). When they are ON, this connects the internal polarisation (typ 680 Ohms) and termination (typ 120 Ohms) resistors. This configuration applies only to RS4xx lines conforming to good practices.

5.4.2 Serial port #2

Specification

 

Value

 

 

 

Physical mode

 

Full RS232

 

 

 

Normal isolation

 

NOT ISOLATED

 

 

 

Pinout connector

 

See label and appendix (Relays output on page 30)

 

 

 

Termination/polarization

 

None

 

 

 

 

Table 11: Serial port 2 specification

page 14 of 35

Image 17
Contents Installation Guide EWON4002 Installation Guide Table Of Contents IP parameters configuration Technical support Product description General specification of the hardware platformIntroduction Ethernet GatewayDatalogger RAS Modem & PIRTypical applications Part Numbers and internal optionsCc= Communication External accessoriesXy = Options Type/Description Part NumberStructure of the eWON technical documentation Level Title ContentsHousing Housing and markingsMarkings Required power supplyApplicable directives, standards and compliance Serial numberMechanical outline Equipment information and versionsSpring Bottom Slider Mounting and environmental conditionsSpecifications for external power supply selection Preparing the installationSpecification Value Auto fuseFront panel control LEDs Embedded Pstn Modem Communication interfaces and I/OsEmbedded GSM/GPRS Modem Ethernet PortSIM-card insertion Recommendations for the GSM/GPRS antennaSerial port #1 Serial port Dip switchSerial ports Serial port #2 Positions ModeSerial port #3 Serial port 3 connector and dip switchDigital Inputs Open collector Digital Output Digital OutputsRelays Configurable standard Analog Inputs AI1 AI4Analog Inputs Resistive Temperature Detector Inputs By Ethernet Communicating with the eWONBy phone line or GSM Under Windows 98, NTUnder Windows XP EWONCFG utility and IP parameter window IP parameters configurationUser Reset ResetsFactory Reset Technical supportPower supply Connector Appendix Pinouts and connections Power SupplyEthernet Ethernet ConnectorDirect connection Crossed CableHub/Router Straight Cable Connection over hub/routerRJ 45 connector/cabling RJ45 connectorDigital Input/Output Connector 1 DI / do connectorDigital Input/Output mating female connector included Digital Input/Output connector pinout Pin DescriptionAnalog Input mating female connector included Analog Input ConnectorAnalog Input connector pinout Pin Description Analog InputRelays Output mating female connector included Relay ConnectorRelays output connector pinout Pin Description Relays outputTop face Digital inputBack face Front Face Digital InputSerial ports connectors Female DB9 with 4/40 blocking screws Pinout serial port Pinout serial ports 1 and 3 according to modePin RS232 RS485 RS422 Pin RS232Connector MiniDIN PIN Schneider Signal EWON Signal Name EWON SUBDB9Unitelway/Modbus serial cable DA is connected to B- and DB is connected to A+Pstn phone line mating male connector not included Pstn phone line connectorPstn phone line Connector