Siemens eWON4002 manual Input/Outputs, 1 DI / do connector, Digital Input/Output Connector

Page 31

eWON4002™

Installation Guide

ver 2 . 04

9.4Input/Outputs

9.4.1 DI / DO connector

Digital Input/Output

connector

Pin 1

Pin 5

Figure 17: Digital Input/Output connector

• Digital Input/Output mating female connector (included):

Manufacturer:	Sauro	http://www.sauro.net/

Part Number:	CTF050VT

Table 20: Digital Input/Output connector references

• Digital Input/Output connector pinout:

Pin	REF	Description

1	DO_GND	Output digital signal (0V ground) connected to the emitter of the transistor

2	DO_OC	Output digital signal connected to the collector of the transistor

3	DO_VDC	Common of the external predrive power supply (between +12 et +24 VDC)

4	DI_GND	Ground of the input (isolated)

5	DI	Input digital signal

Table 21: Digital Input/Output connector pinout

page 28 of 35

Image 31

Contents Installation Guide EWON4002 Installation Guide Table Of Contents IP parameters configuration Technical support Ethernet Gateway General specification of the hardware platformProduct description IntroductionPart Numbers and internal options RAS Modem & PIRDatalogger Typical applicationsType/Description Part Number External accessoriesCc= Communication Xy = OptionsStructure of the eWON technical documentation Level Title ContentsHousing Housing and markingsSerial number Required power supplyMarkings Applicable directives, standards and complianceMechanical outline Equipment information and versionsSpring Bottom Slider Mounting and environmental conditionsAuto fuse Preparing the installationSpecifications for external power supply selection Specification ValueFront panel control LEDs Ethernet Port Communication interfaces and I/OsEmbedded Pstn Modem Embedded GSM/GPRS ModemSIM-card insertion Recommendations for the GSM/GPRS antennaSerial ports Serial port Dip switchSerial port #1 Serial port #2 Positions ModeSerial port #3 Serial port 3 connector and dip switchDigital Inputs Open collector Digital Output Digital OutputsAnalog Inputs Configurable standard Analog Inputs AI1 AI4Relays Resistive Temperature Detector Inputs Under Windows 98, NT Communicating with the eWONBy Ethernet By phone line or GSMUnder Windows XP EWONCFG utility and IP parameter window IP parameters configurationTechnical support ResetsUser Reset Factory ResetPower supply Connector Appendix Pinouts and connections Power SupplyCrossed Cable Ethernet ConnectorEthernet Direct connectionHub/Router Straight Cable Connection over hub/routerRJ 45 connector/cabling RJ45 connectorDigital Input/Output connector pinout Pin Description 1 DI / do connectorDigital Input/Output Connector Digital Input/Output mating female connector includedAnalog Input Analog Input ConnectorAnalog Input mating female connector included Analog Input connector pinout Pin DescriptionRelays output Relay ConnectorRelays Output mating female connector included Relays output connector pinout Pin DescriptionDigital Input Digital inputTop face Back face Front FaceSerial ports connectors Female DB9 with 4/40 blocking screws Pin RS232 Pinout serial ports 1 and 3 according to modePinout serial port Pin RS232 RS485 RS422DA is connected to B- and DB is connected to A+ MiniDIN PIN Schneider Signal EWON Signal Name EWON SUBDB9Connector Unitelway/Modbus serial cablePstn phone line Connector Pstn phone line connectorPstn phone line mating male connector not included