
eWON4002™
Installation Guide
ver 2 . 04
Spring
Bottom
slider
Figure 6: DIN-rail latch
The eWON® must be fastened on a 35mm DIN rail compliant with EN50022.
To put the unit in place, insert the bottom slider into the lower part of the rail, with the eWON® tiled around 20°. Then push the eWON® upward to compress the spring, and at the same time, put the unit right by rotating it. The eWON® is now safely fastened.
3.6 Mounting and environmental conditions
The eWON® unit has an IP31 protection grade. It is therefore not suited for outdoor mounting. The design of the unit is such that it has to be integrated in an enclosed electrical cabinet, protected from excessive heat, humidity and dust. The eWON4002™ is complying to the
The normal mounting position is wall mounted on
The equipment will operate within specified tolerances only if the following environmental conditions are respected:
Ambient temperature range | 0°C to +50°C |
|
|
Ambient humidity | |
|
|
page 8 of 35