SURFboard | Introduction Before You Begin Installation Operation Basic Configuration Troubleshooting |
R |
The SB4100 contains all necessary software. You don't need to configure the SB4100 but you must configure your computer for TCP/IP (software protocol developed for communica- tion between computers) and check for an IP address. Your service provider may provide additional instructions for setting up your computer.
Configuring for TCP/IP
The following basic instructions are for Windows 95 or Windows 98. If you are using a different operating system, refer to that user guide.
1 | On the Windows Desktop, click Start. |
2 | Select Settings and then Control Panel |
| from the |
3 | |
| Control Panel window. |
4 | Select the Configuration tab on the |
| Network window for Windows 95 |
| or Windows 98. |
5 | Check to see if TCP/IP has been |
installed for the device being used (Ethernet card or USB). If TCP/IP appears in the list of network components, it is installed and you can proceed to step 10. If it doesn't appear on the list, continue with step 6.
TM
11