Motorola SB4100 manual SURFboard R

Page 17

SURFboard R

Introduction Before You Begin Installation Operation Basic Configuration Troubleshooting

Configuring for TCP/IP

10 Click TCP/IP on the Network window. If you have more than one TCP/IP entry, choose the one associated with the Ethernet card or USB device connected to the SB4100.

11 Click Properties.

12 Select the IP Address tab on the TCP/IP window.

13 Click Obtain an IP address automatically.

14 Click OK to accept the TCP/IP settings.

15 Click OK to close the Network window.

16 Click OK when a prompt to restart your computer is displayed and then click OK again.

TM

13

Image 17

Contents SURFboard R Declaration of Conformity Regulatory InformationDeclaration of Conformity SB4100 meets one or more of the standards listedRepairs Canadian ComplianceJust open your browser and s u r f SURFboard RDescription Front PanelLINK/ACT Rear PanelEquipment Check SURFboard RSystem Requirements Service ProviderComputer Ethernet Card or USB Special SoftwarePrecautions USB Cabling For a Single UserEthernet Cabling For Multiple UsersEthernet and USB SURFboard RSURFboard R Powering Up the First TimeSURFboard Configuring for TCP/IPClick OK SURFboard R Installing USB Device Drivers SURFboard R Uninstalling for Windows 98 or Windows Me Uninstalling USB Device DriversRight-click SB4100 Uninstalling for WindowsRemoving Operating System O/S Files Files were not fully installedVerifying Your IP Address Problem Problem Possible Solution Software License Notices You may not You mayExport Restriction Government Restricted Rights

Related manuals

Manual 28 pages 2.14 Kb