Motorola manual Uninstalling for Windows, Right-click SB4100

Page 21

SURFboard R

Introduction Before You Begin Installation Operation Basic Configuration Troubleshooting

Uninstalling for Windows 2000

1	On the Windows Desktop, click Start.
2	Select Settings and then Control Panel
	from the pop-up menu.
3	Double-click System.
4	Select the Hardware tab.
5	Click Device Manager (center right in
	window).
6	Double-click Network Adapters.
7	Highlight SB4100.

8 Right-click SB4100.

or

Click Other to locate the SB4100 if it does not appear in the Network Adapters.

9	Click Uninstall.

10 Click OK.

This uninstalls the device from your computer system; however, the operating system (O/S) may leave some driver files on the hard drive. Refer to Removing O/S Files.

TM

17

Image 21

Contents SURFboard R Declaration of Conformity Regulatory InformationDeclaration of Conformity SB4100 meets one or more of the standards listedRepairs Canadian ComplianceJust open your browser and s u r f SURFboard RDescription Front PanelLINK/ACT Rear PanelEquipment Check SURFboard RSystem Requirements Service ProviderComputer Ethernet Card or USB Special SoftwarePrecautions USB Cabling For a Single UserEthernet Cabling For Multiple UsersEthernet and USB SURFboard RSURFboard R Powering Up the First TimeSURFboard Configuring for TCP/IPClick OK SURFboard R Installing USB Device Drivers SURFboard R Uninstalling for Windows 98 or Windows Me Uninstalling USB Device DriversRight-click SB4100 Uninstalling for WindowsRemoving Operating System O/S Files Files were not fully installedVerifying Your IP Address Problem Problem Possible Solution Software License Notices You may not You mayExport Restriction Government Restricted Rights

Related manuals

Manual 28 pages 2.14 Kb