AG Neovo TSC-30/IC manual Storage Specification, Storage Conditions, Baking

Page 20

TSC-30/IC Product Specification

7. Storage Specification

7-1. Storage Conditions

For storing the product until its implementation, it is recommended that the following storage conditions are applied:

1. Before unpacking the damp-proof package (Aluminum laminate bag)

Temperature and humidity:

5 to 40 °C, 20 - 80%RH

Duration:

Two years or less

2.After unpacking the damp-proof package (Aluminum laminate bag)

For the storing duration after the damp-proof package is unpacked and before the implementation, it is recommended that the following storage conditions is to be applied:

(1) Reflow method:

Two weeks or less under the ambient condition: 30 °C, 70%RH or less

3.Temporary storage after damp-proof package is unpacked

To store again temporarily the once unpacked and unused damp-proof package, it is recommended to pack it again into another damp-proof bag with desiccant within a shorter time after opened (Around 10 minutes) as far as possible, and fold the bag’s opening, followed by sealing with adhesive material such as adhesive tape, then store it under the following conditions:

Temperature, humidity:

5 to 40 °C, 20 - 80%RH

Duration:

One month or less

7-2. Baking

If any condition among those 1 to 3 listed below is applicable, it is recommended to apply the baking as described below to dry the moisture the package absorbs.

You may place the tray used for damp-proof packaging directly into the thermostatic chamber since the tray is heat-proof type. When placing into the chamber or after removing from it, to avoid deformation, cool the tray by placing it on the flat plate such as surface table.

1.Any condition among 1 to 3 in [7-1. Storage condition] is unsatisfied

2.Indicator’s 30% Humidity Check section changes the color to lavender or pink

3.Blue color indicator of desiccant (Silica gel) changes to pink or white

Baking method

 

Temperature:

125 °C

Duration:

20 to 24 hours

Frequency:

Four times or less (Upper limit: 96 accumulative hours)

Document No. DER-S0008A

19

Version 1.0 ©2008 DMC Co., Ltd.

Image 20
Contents Page Table of Contents Features Products outlineScope of Application OutlineGeneral specification USBMarking specification Pin layout and representationPin functions BeepPaneladyd Initial setting Eeprom settingCommunication mode setting Touch screen mode settingConfiguration in USB mode Panel ID setting USB modeData sheet Absolute maximum ratingRecommended operational conditions MaximumOutput peak current *2 IOH peak Pin number Timing requirement WH, t WL DC standards Normal Vcc= Icc1 Mode Packaging Specification Basic packagingSmall group packaging Tray specification Product name label specificationBaking Storage SpecificationStorage Conditions Soldering iron Manual soldering Implementation Temperature SpecificationReflow method Infrared reflow, air reflow Terminal Pin Specification CleaningChanges and improvements Version historyWarranty Warranty PeriodWarranty Target Warranty ExceptionsOverall handling OthersPage Page Page Page Page Page Page Page Page Page Page