When the Network Setup Wizard reappears, configure your bindings. See your Windows NT User Guide for more information on bindings.
11.When the bindings are configured, click Next, followed by Next again to start the network.
12.When the Network Wizard window reappears, enter a name for your com- puter. You can name it whatever you would like, (Mary's Computer, Tardis, etc.).
13.Next, choose either Workgroup or Domain, then enter the workgroup or domain name that you want your PC to connect to. If you're not sure of the name, see your Windows NT user guide(s) or check the settings of the other PCs on your network. In most home networking situations, your computers should all have the same Workgroup name.
When you're finished, click on Next, followed by Finish. Choose to restart your computer. If a service pack was previously installed, you must reapply the service pack. After NT restarts, log in. Look at the HomeLink Phoneline + 10/100 Network PC Card's cable coupler. If your cabling is properly attached and the network is detected, the green Link light will be on, and the Activity (ACT) light will be flickering or solid. The installation is complete. You can now access the network at large through the Network Neighborhood icon on the Windows NT desktop.
page 29