Allied Telesis AT-MC602 manual Actual Mbps, Min Mbps, Max Mbps, Status

AT-MC601 and AT-MC602 Installation and User’s Guide

❑Actual (Mbps)

Displays the actual data transfer rate on the line. The software automatically detects this speed.

❑Min (Mbps)

Allows you to adapt the data transfer rate by setting a minimum speed.

❑Max (Mbps)

Allows you to adapt the data transfer rate by setting a maximum speed.

The maximum and minimum speeds in Mbps available in the pull-down menus are:

0.94

1.06

1.41

1.88

2.11

2.81

3.75

4.22

5.63

7.50

8.44

11.26

15.01

16.88 (upstream only)

Status

This field will display “Select speed to set” until you have selected data rates from the upstream and downstream pull-down menus and set the rates by clicking the Apply button. Then reports on the status of the attempt to configure the speeds selected from the upstream and downstream pull-down menus will appear in this field. A successful configuration attempt will cycle though the following status reports:

Looking for link status...

Checking signal/noise ratio

Loading a Configuration DS=1.41 US=2.81

(This report will keep repeating with progressively higher upstream and downstream values until the set rate or the highest possible rate has been achieved.)

Saving config on EEPROM - S Side Saving config on EEPROM - P Side Done

39