Altinex MT106-103 manual Rmc, Rmg, Menu Command Definitions, Using Menu Mode

MULTITASKER

Group Commands

36)	[WR]	Add card(s) to a group
37)	[RMC]	Remove card(s) from group
38)	[RMG]	Delete group
39)	[RD]	Display group members

7.4 MENU MODE

Menu Mode commands allow virtually the same functionality as programming commands. Unlike the programming commands, menu commands prompt the user to select from a list of available options. The system then responds based upon selections made by the user.

The menu-driven commands are only available with MultiTasker systems that have the following front panel firmware:

690-0122-015 = Version 015 or later.

690-0123-004 = Version 004 or later.

690-0124-018 = Version 018 or later.

Send the command [VER] to the system and the feedback will include the following:

690-0122-015 690-0123-004 690-0124-018

Check the last three digits against the numbers above to determine if Menu Mode is available.

7.4.1 MENU COMMAND DEFINITIONS

Refer to section 7.2 for details on card functions and examples. Following is a cross-reference of menu sections versus programming commands.

MENU	COMMAND
Input Select	[IN], [INR]
Setup	[MODER], [BRIGHTm],
	[CONTRm], [COLORm],
Output	[SHARPm], [HUEm],
Properties	[MODEA], [MODET],
	[MODEN], [FREEZ],[+], [-]
Version	[VER]
Status	[C]
Help	[HELP]

7.4.2 USING MENU MODE

Do NOT press any keys except those relating to the current menu. If you press the ENTER key after entering a letter or digit, the original list of systems will be displayed.

1.In order to enter Menu Mode, the system needs to be connected to a computer running RS-232 control software.

2.In the Terminal Window, press the ENTER key on the keyboard.

3.The system checks all MultiTaskers on the RS-232 bus and displays a list of available systems.

Example: 1: U1

2:U2

3:U3

4.Enter the ID number of the desired system. In the example above, enter a “1” for the MultiTasker with unit ID 1.

5.The system then interrogates all the cards available in its enclosure and displays a list of available cards.

Example: 01: MT103-122

02:MT103-123

04:MT106-103

6.Enter the 2-digit ID and a menu for the card will be displayed. In the example above, enter “04” for the MT106-103.

7.The system will prompt for selections specific to the selected card.

8.Read each menu carefully, and continue selecting keys as prompted.

NOTE: Menus for data entry have two

prompts: “Key=” and “ESC” (escape). Press the escape key to return to the previous menu without making changes.

400-0394-007 18