Motorola Canopy Backhaul Module user manual BER Display

Page 49

any one of these criteria are not met the link may still be operational but may have issues time to time.

Note: If a Canopy module is placed into Alignment Mode it will automatically drop into Operational Mode after 15 minutes.

BER Display

Bit Error Rate (BER) Display is utilized by the operator to measure the amount bit errors present in a link. BER Display will only work if the access point module is configured to send the BER stream.

**IMPORTANT** If one access point module in a cluster is set to send a BER stream then all other access point modules in that cluster must be configured in the same fashion.

The field, Measured Bit Error Rate, will display a value that corresponds to the BER at the moment of web browser refresh. An acceptable link will have a BER that is less than 10-4. If the BER is greater than 10-4then the operator needs to evaluate the subscriber and/or access point module installation for potential issues. To refresh the screen, click the Refresh Display button as appropriate or configure the web page auto-refresh option.

Image 49

Contents User Manua L Important Note on Modifications Exposure Note Hardware Warranty in U.S Trademarks, Product Names, and Service Names Table of Contents Getting Started Accessories Appendix Specifications Document Change History Getting StartedCanopy Backhaul Product DescriptionModule Description Operational Mode Alignment Mode Background Information on Networking Definitions System Overview and Site PlanningCanopy Backhaul Masters Slave Site Selection CriteriaPage General Considerations GHz Recommended Frequencies Channel PlansLightning Protection Networking InformationElectrical Requirements Reflector dishes Security DES Encryption Advanced FeaturesSecurity AES Encryption Branding Password password-if-configuredSpecific information on this MIB see RFC 1213 for details Configuration of the Backhaul Modules InstallationUnpack the Canopy Products Installation of the equipment Alignment Click Enable Aiming ModeMAC Address ESN Non-auto-sensing Auto-sensing CablingRJ-45 Crossover Timing Master Timing Slave Interface ScreensQuick Start Timing MasterStatus Page Configuration Luid Webpage Auto Update the web-based interface. never refresh Canopy Default Plug Luid Select Event LogTime & Date Link TestSessions Ethernet Stats GPS StatusExpanded Stats Timing Slave Page Configuration Webpage Auto Update the web-based interface. never refresh AP Eval Date Ethernet Stats Link Test Alignment BER Display Accessories Class Network Portion Host Portion AppendixHTTP, FTP, SNMP, DES SpecificationsWith passive reflector Lbs kg