Motorola Canopy Backhaul Module user manual Timing Slave

Page 41

THE TIMING SLAVE

Status

The Status page contains information on the operation of the product. It is the default web page. The following parameters are displayed:

Device Type: displays the type of Canopy module that is currently being viewed. This field will let the operator know the frequency band of the module, the protocol that it is utilizing, and the MAC address of the module. The frequency band can either be in the 5.2 GHz or 5.7 GHz band. The protocol for a subscriber module must be multipoint. The MAC address will be in the following format, 0a-00-3e-xx-xx-xx.

Software Version: displays the version of the software that is currently loaded into the module. Please make note of this information when obtaining technical support.

FPGA Version: displays the version of the FPGA (field programmable gate array) that is currently loaded into the module. Please make not of this information when obtaining technical support.

Uptime: displays the length of time the module has been operating since power was applied.

System Time: displays the current time, which is inherited from the Canopy System via the registration to an access point module. When the module is registered to a Canopy System where a Cluster Management Module (CMM) is being utilized the time is displayed in Greenwich Mean Time (GMT).

Ethernet Interface: displays the configuration of the Ethernet interface on the module.

Session Status: displays the current session state the module is in. There are four (5) options that will display in this field, scanning, syncing, registering, registered, and alignment

•Scanning – module is cycling through the RF frequencies that it is configured to scan and looking for

Page 40 Page 42
Image 41
Page 40 Page 42
Contents User Manua L Important Note on Modifications Exposure Note Hardware Warranty in U.S Trademarks, Product Names, and Service Names Table of Contents Getting Started Accessories Appendix Specifications Document Change History Getting StartedModule Description Product DescriptionCanopy Backhaul Operational Mode Alignment Mode Background Information on Networking Definitions System Overview and Site PlanningCanopy Backhaul Masters Slave Site Selection CriteriaPage General Considerations GHz Recommended Frequencies Channel PlansElectrical Requirements Networking InformationLightning Protection Reflector dishes Security AES Encryption Advanced FeaturesSecurity DES Encryption Branding Password password-if-configuredSpecific information on this MIB see RFC 1213 for details Unpack the Canopy Products InstallationConfiguration of the Backhaul Modules Installation of the equipment Alignment Click Enable Aiming ModeMAC Address ESN Non-auto-sensing Auto-sensing CablingRJ-45 Crossover Timing Master Timing Slave Interface ScreensQuick Start Timing MasterStatus Page Configuration Luid Webpage Auto Update the web-based interface. never refresh Canopy Default Plug Luid Select Event LogTime & Date Link TestSessions Ethernet Stats GPS StatusExpanded Stats Timing Slave Page Configuration Webpage Auto Update the web-based interface. never refresh AP Eval Date Ethernet Stats Link Test Alignment BER Display Accessories Class Network Portion Host Portion AppendixHTTP, FTP, SNMP, DES SpecificationsWith passive reflector Lbs kg
Top Page Image Contents