Motorola Canopy Backhaul Module user manual Specifications, Http, Ftp, Snmp, Des

Page 52

SPECIFICATIONS

Operating Frequency

U-NII: 5.25 to 5.35 GHz and 5.725 to 5.825 GHz

Range

 

 

ISM: 5.725 to 5.850 GHz

 

 

Access Method

Time Division Multiple Access (TDMA)

 

 

Signaling Rate

10 Mbps or 20 Mbps

 

 

Modulation Type

High Index 2-level or 4-level Frequency Shift Keying (FSK)

 

(Optimized for interference rejection)

 

 

Carrier to Interference

3dB nominal for 10 Mbps

(C/I)

 

 

 

Receiver Sensitivity

-83 dBm 10-4BER for 10 Mbps, -77 dBm 10-4BER for 20 Mbps

 

 

Operating Range

Up to 2 miles (3.6 km) with integrated antenna. Up to 35 miles (56 km)

(All Weather)

with installed passive reflectors.

 

 

Transmitter Power

Meets FCC U-NII/ISM and IC LELAN ERP Limit

 

 

DC Power measured at

0.34 A @ 24 VDC (8.2 watts) typical

DC converter

0.38 A @ 24 VDC (9.1 watts) max (long cable runs, high ambient

 

temperature, high transmit ratio (set by downlink percentage))

 

 

Interface

10/100 BaseT, half/full duplex

 

Rate auto negotiated (802.3 compliant)

 

 

Protocols Used by

IPV4, UDP, TCP, ICMP, Telnet,

Canopy

HTTP, FTP, SNMP, DES

 

 

Protocols Supported by

Switched Layer 2 Transport with support for all common Ethernet

Canopy

protocols including IPV6, NetBIOS, DHCP, IPX, etc.

 

 

Software Upgrade Path

Remotely downloaded into FLASH via RF link

 

 

Network Management

HTTP, TELNET, FTP, SNMP

 

 

Temperature

-40°C to +55°C (-40ºF - +131ºF)

 

 

Dimensions

11.75” H x 3.4” W x 3.4” D (29.9 cm H x 8.6 cm W x 8.6 cm D)

 

 

Weight

1 lb. (.45kg)

 

 

Image 52
Contents User Manua L Important Note on Modifications Exposure Note Hardware Warranty in U.S Trademarks, Product Names, and Service Names Table of Contents Getting Started Accessories Appendix Specifications Getting Started Document Change HistoryCanopy Backhaul Product DescriptionModule Description Operational Mode Alignment Mode Background Information on Networking System Overview and Site Planning DefinitionsSite Selection Criteria Canopy Backhaul Masters SlavePage General Considerations Channel Plans GHz Recommended FrequenciesLightning Protection Networking InformationElectrical Requirements Reflector dishes Security DES Encryption Advanced FeaturesSecurity AES Encryption Password password-if-configured BrandingSpecific information on this MIB see RFC 1213 for details Configuration of the Backhaul Modules InstallationUnpack the Canopy Products Installation of the equipment Click Enable Aiming Mode AlignmentCabling MAC Address ESN Non-auto-sensing Auto-sensingRJ-45 Crossover Interface Screens Timing Master Timing SlaveTiming Master Quick StartStatus Page Configuration Luid Webpage Auto Update the web-based interface. never refresh Canopy Default Plug Event Log Luid SelectLink Test Time & DateSessions GPS Status Ethernet StatsExpanded Stats Timing Slave Page Configuration Webpage Auto Update the web-based interface. never refresh AP Eval Date Ethernet Stats Link Test Alignment BER Display Accessories Appendix Class Network Portion Host PortionSpecifications HTTP, FTP, SNMP, DESWith passive reflector Lbs kg