3Measure the printed template with a ruler to ensure that it is the correct size.
4Use a center punch to mark the center of the holes.
5On the wall, locate the marks for the mounting holes.
Caution
Before drilling holes, check the structure for potential damage to water, gas, or electric lines.
6See step 6 for recommended mounting hardware size. Drill holes to a depth and diameter appropriate for the size and type of hardware you have selected.
7If necessary, install an anchor in each hole.
Use M3.5 x 38 mm (#6 x 1 1/2 inch) screws with a flat underside and maximum screw head diameter of 9.0 mm (.35 inches) to mount the SBV5222.
8Using a screwdriver, turn each screw until the head protrudes from the wall, as shown:
— There must be at least 2.5 mm (.10 inches) between the wall and the underside of the screw head.
— The maximum distance from the wall to the top of the screw head is 6.0 mm (.24 in)
Note: Example above for mounting SBV5222 on a wood surface.
9Place the SBV5222 so the keyholes are above the mounting screws.
10Slide the SBV5222 down so it stops against the top of the keyhole opening.
SBV5222 SURFboard® Digital Voice Modem | 30 |