ADTRAN T200 H2TU-R dimensions Pole Mount Hardware, Mounting Bracket Assembly

Table 3. Pole Mount Hardware

Pole mount kit Pt # 2150090-9

Description	Quantity
*Lifting detail	1
**Pole mount bracket (lifting detail)	1
Pole mounting support bracket	2
3/8 - 16 x 1" Bolts	4
3/8 Flat washer	6
3/8 Split washer	4
3/8 Sealing washer	4

*Fasteners used to attach lifting details are shipped pre-inserted into their designated cabinet locations. **The pole mounting bracket serves as a lifting detail during installation.

4.Attach lifting details. Screwed into each side of the cabinet is a group of three bolts and washers. Remove these for reuse.

NOTE

Observe that one of the lifting details is also the mounting bracket. Ensure the mounting bracket is attached to the side of the cabinet designated to be against the pole.

5.Following the illustration in Figure 8, attach the lifting details to each side of the cabinet using the bolt and washer groups. Ensure the sealing washers are placed between the cabinet and the lifting details. Tighten bolts to 110-130 in-lbs.

WARNING

Exercise caution and observe all safety measures when lifting the cabinet out of the shipping package and during installation.

WARNING

Do not disconnect lifting cable until the cabinet is fully secured and all mounting bracket and support fasteners are tightened.

6.Using appropriately sized and tested hoisting gear, attach a hoist cable between the lifting details. Hoist the cabinet from the package and lower the cabinet onto its side.

Mounting Bracket shown,
Lifting Detail similar.
	Bolt torque:
	110-130 in-lbs
sealing washer
flat washer	bolt
split washer

Figure 8. Mounting Bracket Assembly

7.Remove hardware securing the wooden boards to the bottom of the cabinet.

CAUTION

Do not reuse shipping hardware. It is not designed for cabinet mounting.

8.Identify which side of the cabinet will be mounted to the pole and on that side attach (finger tight) the slotted end of the two bottom support brackets. Ensure the short end will point down after the cabinet is upright and that the sealing washers are against the bottom of the cabinet. Refer to Figure 9. Ensure a flat washer is on both sides of the support bracket.

9.After determining the appropriate upper mounting height of the cabinet, drill a 5/8” hole through the pole for the top pole mounting bracket. The 1/2 inch diameter through-bolt, nut, and washers are customer supplied. Install the bolt through the pole and tighten to leave the bolt head approximately 1 3/4 inches from the pole to allow the upper pole mounting bracket to slide over and down, catching the bolt head. Refer to Figure 10.

10.Maneuver the cabinet so as to fit the through bolt head through the slot key opening on the mounting bracket. When the cabinet is hanging

61150090L1-5A Section 61150090L1-5A, Issue 1 7