Abocom WU5214 user manual Advanced Tab

Page 25

Signal Strength 1

Noise Strength

Transmit

Receive

Link Speed

Throughput

Shows the receiving signal strength, users can choose to display as percentage or dBm format.

Shows the noise signal strength in the wireless environment.

Shows the current Link Speed and Throughput of the transmit rate.

Shows the current Link Speed and Throughput of receive rate.

Shows the current transmitting rate and receiving rate.

Shows the transmitting and receiving speed of data.

Advanced

This Advanced page provides advanced and detailed settings for the wireless network.

Advanced Tab

Wireless mode		Here supports 2.4G (included 802.11b/g/n) wireless mode.


Enable TX Burst		Check to enable this function. This function enables the Wireless LAN USB
		Adapter to deliver better throughput during a period of time, it only takes
		effect when connecting with the AP that supports this function.


Enable TCP Window		Check to increase the transmission quality. The large TCP window size the
Size		better performance.


Fast Roaming at		Check to set the roaming interval, fast to roaming, setup by transmits power.
dBm		(Default setting is -70dBm.)


Show Authentication		When connected AP with authentication, choose whether show
Status Dialog		"Authentication Status Dialog" or not. Authentication Status Dialog displays
		the process about 802.1x authentications.

- 21 -

Image 25

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction FeaturesInstall the Software InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network ConnectionUtility Configuration Network Type Authentication Station ModeProfile Profile TabSystem Configuration tab Lowest Authentication and Security tab802.1x tab ID\PASSWORD tab Tunnel AuthenticationEAP Method EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token CardServer Certification tab Client Certification tabNetwork Tab NetworkGeneral Access Point AP Information802.11n Link StatusLink Status Tab Advanced Tab AdvancedTransmit StatisticsReceive Statistics WMM/ QoSDirect Link Setup Enable WMM Enable WMM- Power Save EnableMAC Address Timeout Value Apply Tear Down WMM/QoS TabWPS Tab WPS AP List Rescan Information PIN Code Config Mode DetailConnect Rotate Disconnect Export Profile Radio On/OffDelete WPS Associate IE WPS Probe IE Auto Progress Bar Status BarAbout Utility Menu ListConfig Soft AP modeConfig Channel Wireless Mode Use Mac Address Security SettingBeacon ms TX Power Idle time60-3600s Access Control MAC Table Access ControlEvent Log Power Saving Mode StatusMAC Table Event LogTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX BurstTransmit Statistics Tab Reset Counter Click this button to reset counters to zeroReceive Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Associate IE Rotate DisconnectWPS Probe IE Progress Bar Status Bar Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s No forwarding Among wirelessClients Hide Ssid Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation