Abocom WU5214 user manual Advanced

Page 50

Link Status Tab

Status

Extra Info

Channel

Authentication

Encryption

Network Type

IP Address

Sub Mask

Default Gateway

Link Quality

Signal Strength 1

Noise Strength

Transmit

Receive

Link Speed

Throughput

Shows the current connected AP SSID and MAC address. If there is no connection existing, it will show Disconnected.

Shows the link status and Tx power percentage.

Shows the current channel in use.

Authentication mode used within the network, including Unknown, Open, Shared, WPA-PSK, WPA2-PSK, WPA and WPA2.

Shows the encryption type currently in use. Valid value includes WEP, TKIP, AES, and Not Use.

Network type in use, Infrastructure for BSS, Ad-Hoc for IBSS network.

Shows the IP address information.

Shows the Subnet Mask information.

Shows the default gateway information.

Shows the connection quality based on signal strength and TX/RX packet error rate.

Shows the Receiving signal strength, users can choose to display as percentage or dBm format.

Shows the noise signal strength in the wireless environment.

Shows the current Link Speed and Throughput of the transmit rate.

Shows the current Link Speed and Throughput of receive rate.

Shows the current transmitting rate and receiving rate.

Shows the transmitting and receiving speed of data.

Advanced

This Advanced page provides advanced and detailed settings for the wireless network.

- 46 -

Image 50

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Federal Communication Commission Interference Statement Country Code StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Features Chapter IntroductionInstallation Install the SoftwarePage Install the Hardware Verification For Windows Vista Page Install the Hardware Network Connection IP AddressUtility Configuration Profile Station ModeNetwork Type Authentication Profile TabSystem Configuration tab Authentication and Security tab Lowest802.1x tab EAP Method Tunnel AuthenticationID\PASSWORD tab EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token CardClient Certification tab Server Certification tabNetwork Network TabAccess Point AP Information GeneralLink Status 802.11nLink Status Tab Advanced Advanced TabStatistics TransmitWMM/ QoS Receive StatisticsMAC Address Timeout Value Apply Tear Down WMM Enable WMM- Power Save EnableDirect Link Setup Enable WMM/QoS TabWPS AP List Rescan Information PIN Code Config Mode Detail WPS TabConnect Rotate Disconnect Delete Radio On/OffExport Profile WPS Associate IE WPS Probe IE Auto Progress Bar Status BarUtility Menu List AboutConfig Soft AP modeConfig Channel Wireless Mode Use Mac Address Security SettingBeacon ms TX Power Idle time60-3600s Access Control Access Control MAC TableMAC Table Power Saving Mode StatusEvent Log Event LogTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Wireless mode Enable TX Burst Enable TCP Window Size Fast Roaming at ApplyReceive Statistics Tab Reset Counter Click this button to reset counters to zeroTransmit Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Probe IE Progress Bar Status Bar Rotate DisconnectWPS Associate IE Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Clients Hide Ssid Among wirelessNo forwarding Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation