Abocom WU5214 user manual Tunnel Authentication

Page 45

certificate-based and mutual authentication of the client and the network. It relies on client-side and server-side certificates to perform authentication and can be used to dynamically generate user-based and session-based WEP keys to secure subsequent communications between the WLAN client and the access point.

Tunnel Authentication:

•Protocol: Tunnel protocol, List information including EAP-MSCHAP v2 and EAP-TLS/ Smart Card.

•Tunnel Identity: Identity for tunnel.

•Tunnel Password: Password for tunnel.

Session Resumption: Reconnect the signal while broken up, to reduce the packet and improve the transmitting speed. Users can click the box to enable or disable this function.

ID\PASSWORD tab:

ID/ PASSWORD: Identity and password for server.

•Authentication ID / Password: Identity, password and domain name for server. Only "EAP-FAST" and "LEAP" authentication can key in domain name. Domain name can be keyed in blank space.

•Tunnel ID / Password: Identity and Password for server.

Show Password: Check this box to show the passwords that have been entered.

OK: Click to save settings and exit this page.

Cancel: Click to call off the settings and exit.

Client Certification tab:

Users can select Use a certificate on this computer, a client certificate for server authentication. Or users can select Use my smart card to enable the Client Certification function.

- 41 -

Image 45

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction FeaturesInstall the Software InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network ConnectionUtility Configuration Network Type Authentication Station ModeProfile Profile TabSystem Configuration tab Lowest Authentication and Security tab802.1x tab ID\PASSWORD tab Tunnel AuthenticationEAP Method EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token CardServer Certification tab Client Certification tabNetwork Tab NetworkGeneral Access Point AP Information802.11n Link StatusLink Status Tab Advanced Tab AdvancedTransmit StatisticsReceive Statistics WMM/ QoSDirect Link Setup Enable WMM Enable WMM- Power Save EnableMAC Address Timeout Value Apply Tear Down WMM/QoS TabWPS Tab WPS AP List Rescan Information PIN Code Config Mode DetailConnect Rotate Disconnect Export Profile Radio On/OffDelete WPS Associate IE WPS Probe IE Auto Progress Bar Status BarAbout Utility Menu ListConfig Soft AP modeConfig Channel Wireless Mode Use Mac Address Security SettingBeacon ms TX Power Idle time60-3600s Access Control MAC Table Access ControlEvent Log Power Saving Mode StatusMAC Table Event LogTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX BurstReset Counter Click this button to reset counters to zero Transmit Statistics TabReceive Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect Rotate Disconnect WPS Associate IEWPS Probe IE Progress Bar Status Bar Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Among wireless No forwardingClients Hide Ssid Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation