Abocom WU5214 Rotate Disconnect, WPS Associate IE, WPS Probe IE Progress Bar Status Bar

Page 56

Rotate

Disconnect

Command to rotate to connect to the next network inside credentials.

Stop WPS action and disconnect this active link. And then select the last profile at the Profile Page. If there is an empty profile page, the driver will select any non-security AP.

Export Profile		Export all credentials to Profile.


Delete		Delete an existing credential. And then select the next credential if exist. If
		there is an empty credential, the driver will select any non-security AP.


PIN		Registrar: Add the AP’s PIN code into the PIN code column, and press the
		device PIN button. It will connect with the AP in two minutes and get IP
		address.
		Enrollee: Input the device’s PIN code into the PIN code column of AP. Start
		AP WPS process and click device PIN button. Then, the device will connect
		to AP in two minutes and get IP address.


PBC		Start to add to AP using PBC (Push Button Configuration) method. Click this
		button to connect the AP which supported WPS function within two minutes.
		Meanwhile, the AP should also click the PBC button simultaneously.


Note:

After the users click PIN or PBC, please do not rescan within two minutes of the connection. If users want to stop this setup within the interval, restart PIN/PBC or click "Disconnect" to stop WPS action.

WPS Associate IE

Send the association request with WPS IE during WPS setup. It is optional for STA.

WPS Probe IE

Progress Bar

Status Bar

Send the probe request with WPS IE during WPS setup. It is optional for STA.

Display rate of progress from Start to Connected status.

Display currently WPS Status.

- 52 -

Image 56

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Federal Communication Commission Interference Statement Country Code StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Features Chapter IntroductionInstallation Install the SoftwarePage Install the Hardware Verification For Windows Vista Page Install the Hardware Network Connection IP AddressUtility Configuration Station Mode Network Type AuthenticationProfile Profile TabSystem Configuration tab Authentication and Security tab Lowest802.1x tab Tunnel Authentication ID\PASSWORD tabEAP Method EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token CardClient Certification tab Server Certification tabNetwork Network TabAccess Point AP Information GeneralLink Status 802.11nLink Status Tab Advanced Advanced TabStatistics TransmitWMM/ QoS Receive StatisticsWMM Enable WMM- Power Save Enable Direct Link Setup EnableMAC Address Timeout Value Apply Tear Down WMM/QoS TabWPS AP List Rescan Information PIN Code Config Mode Detail WPS TabConnect Rotate Disconnect Radio On/Off Export ProfileDelete WPS Associate IE WPS Probe IE Auto Progress Bar Status BarUtility Menu List AboutSoft AP mode ConfigConfig Channel Wireless Mode Use Mac Address Security SettingBeacon ms TX Power Idle time60-3600s Access Control Access Control MAC TablePower Saving Mode Status Event LogMAC Table Event LogTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Wireless mode Enable TX Burst Enable TCP Window Size Fast Roaming at ApplyReceive Statistics Tab Reset Counter Click this button to reset counters to zeroTransmit Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Probe IE Progress Bar Status Bar Rotate DisconnectWPS Associate IE Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Clients Hide Ssid Among wirelessNo forwarding Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation