Abocom WU5214 user manual Config Mode Detail Connect

Page 55

Config Mode

Detail

Connect

Select from the pull-down menu to decide the station role-playing as an Enrollee or an external Registrar.

Click the Detail button to show the information about Security and Key in the credential.

If selected the AP that listed in the WPS Profile List field, click the Detail button to see more AP information.

SSID: Shows the connected AP network name.

BSSID: The MAC address of the connected AP. Fixed and cannot be changed.

Authentication Type: The authentication type support Open, WPA-PSK and WPA2-PSK.

Encryption Type: For Open authentication mode, the selection of encryption type are NONE and WEP. For WPA-PSKand WPA2-PSKauthentication mode, the encryption type supports both TKIP and AES.

Key Length: Only valid when using Open authentication mode and WEP encryption. There are key lengths 5, 10, 13 and 26.

Key Index: Only valid when using Open authentication mode and WEP encryption. There are 1~4 key index.

Key Material: The key material can be used to ensure the security of the wireless network. Fill in the appropriate value or phrase in Key Material field.

Show Password: Check this box to show the passwords that have been entered.

OK: Click to save and apply the new settings.

Cancel: Click to leave and discard the settings.

Command to connect to the selected network inside credentials. The active selected credential is as like as the active selected Profile.

- 51 -

Image 55

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction FeaturesInstall the Software InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network ConnectionUtility Configuration Profile Tab Station ModeNetwork Type Authentication ProfileSystem Configuration tab Lowest Authentication and Security tab802.1x tab EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token Card Tunnel AuthenticationID\PASSWORD tab EAP MethodServer Certification tab Client Certification tabNetwork Tab NetworkGeneral Access Point AP Information802.11n Link StatusLink Status Tab Advanced Tab AdvancedTransmit StatisticsReceive Statistics WMM/ QoSWMM/QoS Tab WMM Enable WMM- Power Save EnableDirect Link Setup Enable MAC Address Timeout Value Apply Tear DownWPS Tab WPS AP List Rescan Information PIN Code Config Mode DetailConnect Rotate Disconnect WPS Associate IE WPS Probe IE Auto Progress Bar Status Bar Radio On/OffExport Profile DeleteAbout Utility Menu ListChannel Wireless Mode Use Mac Address Security Setting Soft AP modeConfig ConfigBeacon ms TX Power Idle time60-3600s Access Control MAC Table Access ControlEvent Log Power Saving Mode StatusEvent Log MAC TableTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX BurstTransmit Statistics Tab Reset Counter Click this button to reset counters to zeroReceive Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Associate IE Rotate DisconnectWPS Probe IE Progress Bar Status Bar Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s No forwarding Among wirelessClients Hide Ssid Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation