Abocom WU5214 user manual Soft AP mode

Page 59

Soft AP mode

Config

Config

SSID

Channel

Wireless Mode

Use Mac Address

Security Setting

AP name of user type. Users also can click Use Mac Address button to display it.

Manually force the AP using the channel. (The system default is CH 1.)

Here supports 2.4G (included 802.11b/g/n) wireless mode.

Click this button to replace SSID by MAC address.

Authentication mode and encryption algorithm used within the AP. (The system default is no authentication and encryption.)

- 55 -

Image 59

Contents 802.11 b/g/n Mini Wireless LAN USB 2.0 Adapter Country Code Statement Federal Communication Commission Interference StatementTable of Contents Uninstallation For Windows 2000/XP For Windows Vista Chapter Introduction FeaturesInstall the Software InstallationPage Install the Hardware Verification For Windows Vista Page Install the Hardware IP Address Network ConnectionUtility Configuration Profile Tab Station ModeNetwork Type Authentication ProfileSystem Configuration tab Lowest Authentication and Security tab802.1x tab EAP-MSCHAP v2, EAP-TLS/ Smart Card, and Generic Token Card Tunnel AuthenticationID\PASSWORD tab EAP MethodServer Certification tab Client Certification tabNetwork Tab NetworkGeneral Access Point AP Information802.11n Link StatusLink Status Tab Advanced Tab AdvancedTransmit StatisticsReceive Statistics WMM/ QoSWMM/QoS Tab WMM Enable WMM- Power Save EnableDirect Link Setup Enable MAC Address Timeout Value Apply Tear DownWPS Tab WPS AP List Rescan Information PIN Code Config Mode DetailConnect Rotate Disconnect WPS Associate IE WPS Probe IE Auto Progress Bar Status Bar Radio On/OffExport Profile DeleteAbout Utility Menu ListChannel Wireless Mode Use Mac Address Security Setting Soft AP modeConfig ConfigBeacon ms TX Power Idle time60-3600s Access Control MAC Table Access ControlEvent Log Power Saving Mode StatusEvent Log MAC TableTransmit Statistics About Launch Config Utility Network Type Authentication Encryption Use Tx Power Channel Power Save Mode RTS Threshold Fragment Threshold Add Authentication and Encryption tab 802.1x tab EAP Method Tunnel Authentication Network Add to Profile WPS CCX Link Status Advanced Enable TCP Window Size Fast Roaming at Apply Wireless mode Enable TX BurstReceive Statistics Tab Reset Counter Click this button to reset counters to zeroTransmit Statistics Tab WMM Enable WPS AP List Config Mode Detail Connect WPS Probe IE Progress Bar Status Bar Rotate DisconnectWPS Associate IE Radio On/Off Utility Menu List Soft AP mode Beacon ms TX Power Idle time60-3600s Clients Hide Ssid Among wirelessNo forwarding Display all MAC Address that users have set Event Log Statistics About Uninstallation Page For Windows Vista Finally, click Finish to complete the uninstallation