ADC EMU-830 user manual Multishelf Configuration, September 25 Provisioning, Logging On

September 25, 2006 Chapter 3: Provisioning

MULTISHELF CONFIGURATION

The sections that follow contain instructions on how to access the EMU-830 console menus to configure and monitor each EMU and DSL circuit in a multishelf network.

Note: Multishelf TAO has two main screens, the Network screen and the Main menu screen. Logging on displays the Network screen (Figure 3-2 on page 3-4); selecting a shelf in the Network screen displays the Main menu screen (Figure 3-3 on page 3-5); typing the letter Q returns to the Network screen; typing the letter Q in the Network screen quits the application. The Multishelf TAO screens illustrated in this practice were displayed by the Windows 3.1 Terminal emulation utility.

Logging On

To log on to the EMU console menus:

Step Action

1Press the SPACEBAR several times to activate the Autobaud feature. Supported baud rates are 1200, 2400, 4800, 9600, and 19200 (recommended). The Logon screen dialog box is displayed (Figure 3-1).

	Figure 3-1. Logon Screen Dialog Box
2	Press ENTER. The Network screen is displayed (see Figure 3-2 on page 3-4).
	Note: The factory-default password is ENTER. If you establish a different password, you must
	type the new password in the Logon screen dialog box on a subsequent log on.
	If the system does not respond, verify that the Hardware Flow Control of the VT-100 terminal
	(or PCs terminal emulation utility) is OFF.
	If the password is forgotten, please contact ADC customer service.

LTPE-UM-3159-02 3-3