Acer ISDN P10 manual Using Multilink in Windows

Page 16

AcerISDN P10 User Manual

Press “Yes” to keep the newer files.

10.If the Microsoft ISDN Accelerator Pack 1.1 or Dial-Up Networking 1.2 is not installed before, you should see the following screen.

FIGURE 2-7: INSTALLING THE MULTILINK PPP FROM MICROSOFT

For more details about multilink PPP, please refer to

Section 2.6, Using Multilink in Windows 95.

12.After installing the Microsoft ISDN Accelerator Pack 1.1 or Dial-Up Networking 1.2, you will be prompted to restart the computer.

FIGURE 2-8: RESTARTING THE COMPUTER

12

Image 16

Contents Trademarks CE/EMC Restriction of Liability Table of Contents Table of Figures Introduction An Overview of the AcerISDN P10Isdn System Package Contents AcerISDN P10 Features Installation Before InstallingInstalling the Isdn Card 1CONNECTING the Isdn Line Installing the AcerISDN P10 Drivers For Windows 95 and OEM Service Release 2 OSR2Acerisdn P10 PNP Card Detected in OSR2 Configuring the Isdn Card Entering the Path of Windows 95 Disk Using Multilink in Windows Installation Device Manager 10 Device Properties Window For Windows NT 12 Setup Program of the Isdn Card 13 Entering the Path of Windows NT Disk 15 List of RAS Communication Ports 16 Acerisdn P10 Installed AS a Network Adapter AcerISDN P10 Utility Installation 17 Installing the Utility ProgramsDiagnostic Program 18 the Diagnostic Program19 the Loopback Test Using Multilink in Windows Installation Page Uninstalling the AcerISDN P10 20 the Uninstallation ProgramTroubleshooting Troubleshooting ProceduresError Possible Message Cause Remedy Error Possible Message Cause Remedy Troubleshooting Resource IRQ and I/O Port information Own Isdn Product Support