Acer ISDN P10 manual Installation, Before Installing

Page 9

Chapter 2

Installation

2.1 Before Installing

Make sure that you have all you need to install the AcerISDN P10 ISDN card. You should have the following:

1.An IBM compatible 486 DX2-66 or above with at least 8MB of RAM.

2.One unused 16-bit expansion ISA bus slot.

3.One free interrupt (IRQ).

4.Microsoft Windows 95 or NT.

5.CR-ROM drive.

6.At least 5MB of free disk space for the AcerISDN P10 controller software.

7.A VGA compatible monitor.

8.An IBM or Microsoft compatible mouse.

9.An ISDN basic rate S0 interface released by PTT (Post, Telephone and Telegraph administration).

Image 9

Contents Trademarks CE/EMC Restriction of Liability Table of Contents Table of Figures An Overview of the AcerISDN P10 IntroductionIsdn System Package Contents AcerISDN P10 Features Before Installing InstallationInstalling the Isdn Card 1CONNECTING the Isdn Line For Windows 95 and OEM Service Release 2 OSR2 Installing the AcerISDN P10 DriversAcerisdn P10 PNP Card Detected in OSR2 Configuring the Isdn Card Entering the Path of Windows 95 Disk Using Multilink in Windows Installation Device Manager 10 Device Properties Window For Windows NT 12 Setup Program of the Isdn Card 13 Entering the Path of Windows NT Disk 15 List of RAS Communication Ports 16 Acerisdn P10 Installed AS a Network Adapter 17 Installing the Utility Programs AcerISDN P10 Utility Installation18 the Diagnostic Program Diagnostic Program19 the Loopback Test Using Multilink in Windows Installation Page 20 the Uninstallation Program Uninstalling the AcerISDN P10Troubleshooting Procedures TroubleshootingError Possible Message Cause Remedy Error Possible Message Cause Remedy Troubleshooting Resource IRQ and I/O Port information Own Isdn Product Support