Acer manual Uninstalling the AcerISDN P10, the Uninstallation Program

Page 31

Chapter 2 — Installation

2.7 Uninstalling the AcerISDN P10

The setup information for the AcerISDN P10 is saved by Windows. If you decide to permanently remove the AcerISDN P10 from your system, you must run the uninstallation program from the AcerISDN P10 program group. To remove the driver and utility Programs of the AcerISDN P10 from your system, please follow these steps.

1.Open the “Programs” folder on the “Start” menu and click the “AcerISDN P10” item.

2.Click the “Uninstall DRV & UTL” item. The uninstallation program will run.

FIGURE 2-20: THE UNINSTALLATION PROGRAM

3.Check the items that you want to completely remove from the system and press “OK”.

This concludes Chapter 2. Chapter 3 covers troubleshooting.

27

Image 31

Contents Trademarks CE/EMC Restriction of Liability Table of Contents Table of Figures An Overview of the AcerISDN P10 IntroductionIsdn System Package Contents AcerISDN P10 Features Before Installing InstallationInstalling the Isdn Card 1CONNECTING the Isdn Line For Windows 95 and OEM Service Release 2 OSR2 Installing the AcerISDN P10 DriversAcerisdn P10 PNP Card Detected in OSR2 Configuring the Isdn Card Entering the Path of Windows 95 Disk Using Multilink in Windows Installation Device Manager 10 Device Properties Window For Windows NT 12 Setup Program of the Isdn Card 13 Entering the Path of Windows NT Disk 15 List of RAS Communication Ports 16 Acerisdn P10 Installed AS a Network Adapter 17 Installing the Utility Programs AcerISDN P10 Utility Installation18 the Diagnostic Program Diagnostic Program19 the Loopback Test Using Multilink in Windows Installation Page 20 the Uninstallation Program Uninstalling the AcerISDN P10Troubleshooting Procedures TroubleshootingError Possible Message Cause Remedy Error Possible Message Cause Remedy Troubleshooting Resource IRQ and I/O Port information Own Isdn Product Support