Acer manual AcerISDN P10 Utility Installation, Installing the Utility Programs

Page 25

Chapter 2 — Installation

2.4 AcerISDN P10 Utility Installation

To install the utility programs, please follow the instructions listed below.

1.Insert the AcerISDN P10 Utility Installation Diskette or CD into drive A: (B:, or D:, etc.).

2.On the task bar, press “Start” and then click “Run”. The Program Run dialog box will open.

FIGURE 2-17: INSTALLING THE UTILITY PROGRAMS

Type “D:\UTILITY\SETUP” in the Run Dialog Box.

Press “OK”. The InstallShield Wizard will load the

AcerISDN P10 utility installation program.

Press “Next>” to begin installing the AcerISDN P10 Utility. Follow the instructions on the screen to complete the installation.

The next section describes how to use the diagnostic program to check the card configuration.

21

Image 25

Contents Trademarks CE/EMC Restriction of Liability Table of Contents Table of Figures An Overview of the AcerISDN P10 IntroductionIsdn System Package Contents AcerISDN P10 Features Before Installing InstallationInstalling the Isdn Card 1CONNECTING the Isdn Line For Windows 95 and OEM Service Release 2 OSR2 Installing the AcerISDN P10 DriversAcerisdn P10 PNP Card Detected in OSR2 Configuring the Isdn Card Entering the Path of Windows 95 Disk Using Multilink in Windows Installation Device Manager 10 Device Properties Window For Windows NT 12 Setup Program of the Isdn Card 13 Entering the Path of Windows NT Disk 15 List of RAS Communication Ports 16 Acerisdn P10 Installed AS a Network Adapter 17 Installing the Utility Programs AcerISDN P10 Utility Installation18 the Diagnostic Program Diagnostic Program19 the Loopback Test Using Multilink in Windows Installation Page 20 the Uninstallation Program Uninstalling the AcerISDN P10Troubleshooting Procedures TroubleshootingError Possible Message Cause Remedy Error Possible Message Cause Remedy Troubleshooting Resource IRQ and I/O Port information Own Isdn Product Support