Acer ISDN P10 manual For Windows NT

Page 20

AcerISDN P10 User Manual

For Windows NT 4.0:

1.Start Windows. Run “D:\DRIVERS\WINNT40\SETUP.BAT” in the Driver Installation Diskette or CD.

FIGURE 2-11: ADDING THE ACERISDN P10 AS A NETWORK

ADAPTER

2.Click “OK” again to begin copying files.

3.After that, the “Setup Program” will start.

16

Image 20

Contents Trademarks CE/EMC Restriction of Liability Table of Contents Table of Figures Introduction An Overview of the AcerISDN P10Isdn System Package Contents AcerISDN P10 Features Installation Before InstallingInstalling the Isdn Card 1CONNECTING the Isdn Line Installing the AcerISDN P10 Drivers For Windows 95 and OEM Service Release 2 OSR2Acerisdn P10 PNP Card Detected in OSR2 Configuring the Isdn Card Entering the Path of Windows 95 Disk Using Multilink in Windows Installation Device Manager 10 Device Properties Window For Windows NT 12 Setup Program of the Isdn Card 13 Entering the Path of Windows NT Disk 15 List of RAS Communication Ports 16 Acerisdn P10 Installed AS a Network Adapter AcerISDN P10 Utility Installation 17 Installing the Utility ProgramsDiagnostic Program 18 the Diagnostic Program19 the Loopback Test Using Multilink in Windows Installation Page Uninstalling the AcerISDN P10 20 the Uninstallation ProgramTroubleshooting Troubleshooting ProceduresError Possible Message Cause Remedy Error Possible Message Cause Remedy Troubleshooting Resource IRQ and I/O Port information Own Isdn Product Support