Acer ISDN P10 manual Setup Program of the Isdn Card

Page 21

Chapter 2 — Installation

FIGURE 2-12: SETUP PROGRAM OF THE ISDN CARD

4.If your PC has PnP BIOS, you can choose “Auto Setting”. Then the IRQ and I/O Port of the ISDN card will be configured by the system.

5.Select the signalling protocol and PCM coding rule of the ISDN switch. Input the ISDN number and click “OK”.

6.After setting the properties of the ISDN card, you might see the following screen prompting for the path of the Windows NT source files to installing the Remote Access Service (RAS).

17

Image 21

Contents Trademarks CE/EMC Restriction of Liability Table of Contents Table of Figures An Overview of the AcerISDN P10 IntroductionIsdn System Package Contents AcerISDN P10 Features Before Installing InstallationInstalling the Isdn Card 1CONNECTING the Isdn Line For Windows 95 and OEM Service Release 2 OSR2 Installing the AcerISDN P10 DriversAcerisdn P10 PNP Card Detected in OSR2 Configuring the Isdn Card Entering the Path of Windows 95 Disk Using Multilink in Windows Installation Device Manager 10 Device Properties Window For Windows NT 12 Setup Program of the Isdn Card 13 Entering the Path of Windows NT Disk 15 List of RAS Communication Ports 16 Acerisdn P10 Installed AS a Network Adapter 17 Installing the Utility Programs AcerISDN P10 Utility Installation18 the Diagnostic Program Diagnostic Program19 the Loopback Test Using Multilink in Windows Installation Page 20 the Uninstallation Program Uninstalling the AcerISDN P10Troubleshooting Procedures TroubleshootingError Possible Message Cause Remedy Error Possible Message Cause Remedy Troubleshooting Resource IRQ and I/O Port information Own Isdn Product Support