Cisco Systems UBR7100E Indentifing Interface Information in the Software, Router# show interfaces

Page 32

Functional Overview

Figure 1-5 Slot Numbering—Cisco uBR7100 Series

PCMCIA Card slots (covered)

Slot 3 Slot 0

5				ACT	OT 0	SLOT 1
								PWR
I	DS0		FE 0/0	FE 0/1
	RF	DS0	FE 0/0	FE 0/1				SYS
		DS0	US3			CONS	AUX	RDY
			US2	US1		CONS	AUX	RDY
				US1		US0
						EN
						uBR7114

Slot 1

Chapter 1 Product Overview

37634

Note The slots for the PCMCIA flash disk memory cards are identified as slot 0 and slot 1 on the chassis, but they are referenced as disk0 and disk1 when using Cisco IOS commands.

Indentifing Interface Information in the Software

You can identify interfaces by using software commands. To display information about all interfaces, use the show interfaces command. To display information about a specific interface, use the show interfaces command with the interface type, slot number, and port number in the format show interfaces type slot/port.

The following example shows how the show interfaces command, used without arguments, displays status information (including the slot and port number) for each interface in a Cisco uBR7100 series router. In the following example, most of the status information for each interface is omitted:

Router# show interfaces

FastEthernet0/0 is up, line protocol			is up
Hardware	is DEC21140A, address is		0002.b9ff.7c00 (bia 0002.b9ff.7c00)
Internet	address	is 10.7.35.1/16
MTU 1500	bytes, BW 100000 Kbit, DLY 100 usec,
(statistical		information omitted)
FastEthernet0/1 is		administratively	down, line protocol is down
Hardware	is DEC21140A, address is		0002.b9ff.7c01 (bia 0002.b9ff.7c01)
Internet	address	is 10.1.1.2/24
MTU 1500	bytes, BW 100000 Kbit, DLY 100 usec,
(statistical		information omitted)
Cable1/0 is up, line protocol is up
Hardware	is BCM3210 ASIC, address		is 0002.b9ff.7c1c (bia 0002.b9ff.7c1c)
Internet	address	is 20.35.1.1/16
MTU 1500	bytes, BW 27000 Kbit, DLY 1000 usec,
(statistical		information omitted)

Interface Cable1/0 Hardware is IMC11

BCM3210 revision=0x56B2

Upconverter info: Config status 0x4E, Dynamic Status 0x0 Upconverter output is Enabled

(statistical information omitted)

			Cable1/0 Downstream		is up
			Frequency	669.0000	MHz, Channel Width 6 MHz, 256-QAM, Symbol Rate 5.360537 Msps
			FEC ITU-T	J.83 Annex B, R/S Interleave I=32, J=4
			Downstream channel		ID: 0
			Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide


	1-12				OL-5916-01
	1-12				OL-5916-01

Image 32

Contents Corporate Headquarters Text Part Number OL-5916-01Copyright 2004 Cisco Systems, Inc. All rights reserved N T E N T S IiiPreparing for Installation Maintenance EuroDOCSIS Upstream and Downstream Specifications A-5 Preface PurposeAudience ViiOrganization Related DocumentationChapter Description ViiiConventions Safety Warning Bewaar Deze InstructiesAviso Instruções Importantes DE Segurança Warnung Wichtige SicherheitshinweiseAvvertenza Importanti Istruzioni Sulla Sicurezza Spara Dessa Anvisningar XiiGEM Disse Anvisninger XiiiXiv Terms and Acronyms Xvi Obtaining Documentation Cisco.comOrdering Documentation XviiSubmitting a Service Request Documentation FeedbackObtaining Technical Assistance Cisco Technical Support WebsiteXix Definitions of Service Request SeverityObtaining Additional Publications and Information Preface Obtaining Additional Publications and Information Product Overview Product DescriptionCisco uBR7100 Series Router Operational Features Cisco uBR7100 Series ModelsCisco uBR7111 and Cisco uBR7111E Cisco uBR7114 and Cisco uBR7114ECisco uBR7100 Series Routers Physical Description DS0 RF Cisco uBR7100 Series Front Panel RF Cable Interface Fixed Interface UnitsEthernet/Fast Ethernet LAN Interface Field-Replaceable Units Port AdaptersWAN Technology Product Description End of Life Flash Disks Memory Size Product Number Spare Product NumberTotal Sdram Memory Configuration Product Number Sdram MemoryChassis Slot and Logical Interface Numbering Functional OverviewRack-Mount and Cable-Management Kit Indentifing Interface Information in the Software Router# show interfacesMAC Addresses Online Insertion and Removal Peripheral Component Interconnect BusesNetwork Processor Card Front Memory Type Size Quantity Description LocationOther Interfaces Router# show versionSystem LEDs and Reset Button DS0 RFLED Label Color State Function SYS RDYOL-5916-01 Preparing for Installation Tools and Parts RequiredShipping Container Contents Safety Guidelines Electrical Equipment GuidelinesPreparing for Installation Safety Guidelines Electrostatic Discharge Prevention Chassis Lifting GuidelinesSite Requirement Guidelines Rack-Mounting GuidelinesCisco uBR7114 Router Footprint and Outer Dimensions Temperature and Humidity Requirements Power Connection Guidelines Specification Minimum MaximumPlant Wiring Guidelines Interference ConsiderationsPort Adapter WAN Connections Distance Limitations and Interface SpecificationsEthernet Connections Console and Auxiliary Port Considerations Console Port ConnectionsAuxiliary Port Connections OL-5916-01 Installing Cisco uBR7100 Series Universal Broadband Routers Physical PlacementMounting the Chassis on a Tabletop Cisco uBR7100 series router Chassis bottomRack-Mounting the Chassis Attaching the BracketsInstalling the Chassis in a Rack Brackets can also be installed with the front panel forwardAttaching the Ground Wire Attaching the System Ground ConnectionAttaching the Ground Wire to the Grounding Lug Attaching the Cable-Management Bracket Connecting to the Network Connecting Upstream and Downstream PortsConnecting the Fast Ethernet Ports 10 Connecting the LAN Port to an Ethernet HubConnecting the Console Port and Auxiliary Port Connecting to the Console PortConnecting a Modem to the Auxiliary Port 12 Connecting a Modem to the Auxiliary PortConnecting the Power 13 Connecting the AC Power CordSystem Startup Checking Conditions Prior to System StartupStarting the System Restricted Rights LegendSystem LEDs These LEDs remain off during normal operation of the router Before You Call for Technical Assistance Troubleshooting the InstallationTroubleshooting Overview Locating the Serial Number on Your Router Problem Solving Using a Subsystems ApproachIdentifying Startup Problems Troubleshooting Strategy for Startup Problems Troubleshooting the Power Subsystem Troubleshooting the Processor SubsystemTroubleshooting the Network Processor Card Troubleshooting the Port Adapter and Fixed RF PortsTroubleshooting the Cooling Subsystem Queued messagesMaintenance Online Insertion and RemovalEnvironmental Monitoring and Reporting Functions Environmental MonitoringDisplaying Environmental Status Reports Parameter High Warning High CriticalRouter# show environment last Fan Failures Flash Memory Card UsageInserting a Flash Memory Card Front Back Inserting and Ejecting a Flash Disk Memory Card Removing a Flash Memory Card Formatting a Flash Memory CardCopying a Bootable Image onto a Flash Memory Card Memory Card section on page 6-8. Then proceed to StepCopying Bootable Images Between Flash Memory Cards Insert the new flash memory card into slotUpgrading the Sdram Memory Modules Removing the Chassis Cover Cover screwsRemoving the Sdram Dimm Removing the CoverBack Front Replacing the Sdram Dimm 10 Handling the DimmReplacing the Chassis Cover 11 Inserting the DimmPowering On the Router 12 Replacing the Chassis CoverOL-5916-01 Description Specification System SpecificationsPhysical Specifications Router Model Upstream Modulation If OutputRF Specifications Docsis Upstream and Downstream SpecificationsSpecification Docsis Specifications1 Minimum Settings2 Upstream Bandwidth Qpsk Data Throughput QAM Data ThroughputTable A-6 Docsis Cable Downstream RF Specifications EuroDOCSIS Upstream and Downstream Specifications Minimum Settings2 Your Headend SettingsTable A-8 EuroDOCSIS Cable Downstream RF Specifications Integrated Upconverter Specifications OL-5916-01 Manufacturer1 Website or Phone Number Products/Model Manufacturers for Headend Provisioning RequirementsNorth American Channel Plans Manufacturer Website or Phone Number Products/Model Agilent Agilent 89411AEuropean Channel Plans Agilent Agilent 8591C Tektronix 2715 Sunrise Telecom AT2000R Cable Specifications Coaxial CablesConsole and Auxiliary Port Cables and Pinouts Identifying an RJ-45 Rollover CableConsole Port Cables and Pinouts RJ-45-to-DB-9Identifying an RJ-45 Crossover Cable Fast Ethernet Port Cables and PinoutsAuxiliary Port Cables and Pinouts Identifying an RJ-45 Straight-Through Cable RJ-45 Pin DescriptionFiber-Optic Cables and Connectors Figure C-5 Duplex SC Cable ConnectorLaser Classification Labels Figure C-8 Laser Caution LabelOL-5916-01 Frequency Allocation Tables Standards Comparisons B1, G D1, KNtsc Cable Television Channels and Relative Frequencies Freq MHz Carrier Visual Aural Channel Bandwidth Visual Center Freq MHz Carrier Visual Aural Channel Bandwidth Visual Center Ntsc M Cable Television Frequencies for Japan Table D-5 Japanese Channel Assignments PAL/SECAM Cable Television Channels and Relative Frequencies Channel Bandwidth Visual Carrier Aural Carrier Number MHzChannel Bandwidth Visual Carrier Aural Carrier Number MHz Channel Bandwidth Visual Carrier Aural Carrier Number MHz Channel Bandwidth Visual Carrier Aural Carrier Number MHz OL-5916-01 Site Log Date InitialsD E IN-1CPU reset button IN-2Pcmcia IN-3HFC C-1 IN-4Location Memory options Memory types PCI bus IN-5Snmp IN-6Tap manufacturers IN-7Wrist straps, attaching IN-8

Related manuals

Manual 20 pages 44.41 Kb