AT&T 2.1.1 manual Testing Extensions and Connections, Channel Assignments Service Extension

Page 14

Overview and Testing

Testing Extensions and Connections

The Switch Administrator now needs to assign analog lines and extensions for each AUDIX Voice Power channel. Service Technicians should then run the lines and perform ring-through tests to determine that all lines are working. This procedure verifies that connections can be established over each circuit.

Before proceeding, record the extension numbers that the Switch Administrator has assigned to each channel on FORM A in the Planning Guide. A sample is shown below.

WARNING:

Do not use an ambiguous extension for the DCP board or for any of the channels assigned to AUDIX Voice Power. An ambiguous extension is one that is shorter than the maximum length and also starts with a digit that could be part of a longer extension under the switch dial plan.

FORM A

Channel Assignments

Channel

Service

Extension

o

1

2

3

4

5

6

7

8I

10

11

1-4

Image 14
Contents Audix Voice Power 1991 AT&T All Rights Reserved Trademark NoticeContents System 75 and Definity G1 Initial Implementation IndexFigures About This Guide Purpose and ScopeIntended Audience AssistanceHow to Use This Guide Conventions Used in this GuideInformation Conventions Related Documents SystemOverview Integrated SystemsSpeech Hardware ConfigurationNon-Integrated Systems Disk SizeSoftware Configuration Unix Operating SystemTesting Extensions and Connections Channel Assignments Service ExtensionAssigning Information Service for Testing Reaching the Configuration Management MenuContinue with Entering the Channel Assignments for Testing Entering the Channel Assignments for Testing Voice Equipment window appearsCHN CD.PT State Page Placing All Channels In Service for Testing Page Page Verifying Extensions Mapping the Phone Extensions to Channels Integrated Only Voice Equipment and press Enter Page Page Actual Service Assigning Services to ChannelsActual Service Provided on Integrated Systems Assigned Service Direct Call Coverage CallActual Service Provided on Non-Integrated Systems Entering Service Assignments Voice Equipment window appears Press F8 CHG-KEYS Page Audix Voice Power Initial Implementation Press F3 Save Changing Service AssignmentsChanging Switch Interface Parameters Switch Interface Administration ParametersSwitch Interface Administration Voice System Administration menu appears Switch Interface Administration form appears Page Verifying System Parameters Verifying Message Waiting Lamp ParametersDisplaying Feature Access Codes System 75/DEFINITY G1 Feature Access Code FormSystem Parameter Administration Entering System ParametersSystem 75 and Definity G1 Initial Implementation Verifying Software ReleaseMusic On Hold Accessing the DCP Extension R1V1Release R1V1 and R1V2 Software Limitations Stations Supported R1V1 Accessing the DCP Extension R1V2Upgrade Installation Audix Voice Power Checklist Integrated Only Assigning Class of Restrictions28? y 36? y 44? y 52? y Class of Restriction Verifying Analog Charnel Administration Enter Type as Configuring DCP Extensions Integrated Only System 75 and Definity G1 Initial Implementation Integrated Mode Administering Hunt GroupsNon-Integrated Mode Creating Hunt Groups Hunt GroupAdministering Call Coverage Creating Coverage PathsPerforming Subscriber Administration Changing Coverage PathsAssign LWC Activation? as y Administering Trunk Names Integrated Only Press Enter Application Package Administration menu appears Press any key to continue Handling Ambiguous Extensions Handling Display PhonesIndex IN-1IN-2 Index
Related manuals
Manual 195 pages 12.71 Kb Manual 231 pages 48.05 Kb