AT&T 2.1.1 manual Changing Coverage Paths, Performing Subscriber Administration

System 75 and DEFINITY G1 Initial Implementation

Changing Coverage Paths

Use the change coverage path command to make the appropriate changes.

	COVERAGE PATH		Page 1 of 1
Coverage Path Number: 6
Next Path Number:		Linkage:
COVERAGE CRITERIA
Station/Group Status	Inside Call	Outside Call
Active?	n	n
Busy?	y	y
Don’t Answer?	y	y	Number of Rings: 2
SAC/Go to Cover?	n	n
	y	y
COVERAGE POINTS
Point1: h7		Point3:
Point2:

Figure 3-8. Call Coverage Form

Performing Subscriber Administration

Verify the information for each subscriber on the switch who will be a subscriber on the AUDIX Voice Power using the change station command. Assign each station’s parameters as follows (see Figure 3-9):

1.Verify that the Name: field exactly matches the name recorded on FORM D in the Planning Guide. If not, change FORM D.

2.Enter the coverage path number which contains either the DCP extension (for integrated systems) or the Call Answer Hunt Group extension

(for non-integrated systems).

3.Enter 1 as the COR or whatever COR was assigned to Subscribers. (Integrated only.) (See Figure 3-1.)

3-15