Ricoh PJ WX3231N Preparing and using the remote control,  Operating the remote Control

Preparing and using the remote control

Loading dry-cell batteries into the remote control

1Remove the battery cover.

2Insert the dry-cell batteries.

Be sure to align the plus and minus ends of the batteries properly.

Operating the remote

control

Point toward the projector’s infrared remote sensor, and press any button on the remote control.

• Operating the projector from the front

Approx.15°

Appro x.5m

Preparations

Two batteries (LR03, SIZE AAA) are used.

3Replace the battery cover.

Note:

When operating the remote control from behind the projector, the infrared signal is reflected on the projecting surface. The operating range therefore may decrease depending on the shape and material of the projecting surface.

Dry-cell batteries

•Before using the batteries, be sure to observe the Safety Precautions described in previous pages.

•Remove batteries from remote control when not using for extended periods.

•If the remote control stops working, or if its range decreases, replace all the batteries with new ones. (2 batteries (LR03 SIZE AAA))

•Keep the batteries away from the reach of children.

Batteries are choking hazards and can be very dangerous if swallowed. If the batteries are swallowed, seek medical assistance immediately.

The remote control

•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.

•Do not drop or bang.

•Do not leave in hot or humid locations.

•Do not allow it to get wet or place it on top of wet objects.

•Do not take it apart.

•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.

19