Attaching the Power Cord and Testing the Printer
1. Plug one end of the power cord into the connector on the printer.
2.Plug the other end into a properly grounded AC outlet.
3.Turn the printer on.
4.As the printer powers up, all operator panel lights turn on briefly.
When only the READY light is steadily on, press and hold the operator panel button until all lights are blinking (approximately four seconds), then release the button. A test page should print out. If this does not happen,
ERROR |
MANUAL |
PAPER |
READY |
The test page lists your printer model and default settings along with the data streams available for your printer model.