Samsung ML-3051ND manual Maintenance parts, Clearing the Toner Low Replace Toner message

Page 41

3Remove the new toner cartridge from its bag.

Caution

Do not use sharp objects, such as a knife or scissors, to open the toner cartridge package. They might scratch the drum of the cartridge.

4Remove the packing tape and roll the cartridge 5 or 6 items to distribute the toner.

Thoroughly roll the cartridge to assure maximum copies per cartridge. Save the box and the plastic bag for shipping.

Cautions

• If toner gets on your clothing, wipe it off with a dry cloth and wash clothing in cold water. Hot water sets toner into fabric.

To prevent damage to the toner cartridge, do not expose it to light for more than a few minutes. Cover it with a piece of paper, if necessary.

Do not touch the green surface underside of the toner cartridge. Use the handle on the cartridge to avoid touching this area.

5Hold the toner cartridge by the handle and slowly insert the cartridge into the opening in the printer.

6Tabs on the sides of the cartridge and corresponding grooves within the printer will guide the cartridge into the correct position until it locks into place completely.

Clearing the Toner Low Replace Toner message

When the Toner Low Replace Toner message appears you can configure not to see this message again not to disturb you.

1Press Menu until System Setup appears on the bottom line of the display and press OK.

2Press the Scroll buttons until Maintenance appears and press OK.

3Press the Scroll buttons until CLR Empty Msg. appears and press OK.

4Select On and press OK.

5Now the Toner Low Replace Toner message does not appear but the Replace Toner message will remain for reminding you that the new cartridge needs to be installed for quality.

Caution

Once you have selected On, this setting will be permanently written to the memory of the toner cartridge, and this menu will be disappeared from the Maintenance menu.

Maintenance parts

To avoid print quality and paper feed problems resulting from worn parts and to maintain your printer in top working condition the following items will need to be replaced at the specified number of pages or when the life span of each item has expired.

Items

Yield (Average)

 

 

Transfer roller

70,000

 

 

Pick-up roller

150,000

 

 

Fuser unit

80,000

 

 

Samsung highly recommends that an authorized service provider, dealer or the retailer where you bought printer performs this maintenance activity.

7Close the front cover. Make sure that the cover is securely closed.

8.4 <Maintenance>

Image 41
Contents Page Page Contact Samsung worldwide Switzerland Contents Troubleshooting MaintenanceInstalling accessories SpecificationsImportant Precautions and Safety Information FCC Regulations FCC Statement for Wireless LAN useCanadian Radio Interference Regulations Federal Communications Commission FCCEuropean States with restrictions on use European States qualified under wireless approvalsWireless Guidance Replacing the Fitted Plug for UK Only Special features Printer overview Finding more information Special featuresIntroduction You can print in Windows 95/98/Me/NT 4.0/2000/XP/2003Front view Features ML-3050 ML-3051N ML-3051NDPrinter overview ML-3051N and ML-3051ND Rear view Control panel overviewFinding more information Using control panel menus ML-3051N,ML-3051NDonly System setupAccessing control panel menus Menu overviewLayout menu Information menuGraphic menu Paper menuEmulation menu System Setup menuPostScript Changing the display language ML-3051N,ML Printing a demoNetwork menu ML-3050, ML-3051NUsing toner save mode Changing the font settingUsing the control panel button From the software applicationSupplied software Software overviewFeature Printer driver featuresSystem requirements WindowsRequirements LinuxMacintosh Configuring TCP/IP Network setupVia network administration programs Supported operating systemsConfiguring IPX frame types Configuring EtherTalkDynamic addressing BOOTP/DHCP Static addressingRestoring the network configuration Setting Ethernet speedPrinting a network configuration Using SetIP programSelecting print media Loading print mediaSupported sizes of paper Type Size Dimensions Weighta CapacitybMedia type Guidelines Guidelines for selecting and storing print mediaGuidelines for special print media Loading paper Changing the size of the paper in the tray Using the tray 1 or the optional trayLoad the paper with the side to be printed on facing up Using the multi-purpose trayTips on using the multi-purpose tray Using manual feed modePrinting to the rear cover Face up Selecting an output locationPrinting to the output tray Face down Printing a document Canceling a print job Canceling a print jobBasic printing Printing a documentAccessories Ordering supplies and accessoriesHow to purchase Toner cartridges Cleaning the printer Maintenance Cleaning the outside of the printer Cleaning the inside of the printerChecking the remaining toner Maintaining the toner cartridgeReplacing the toner cartridge Redistributing toner cartridgeToner Low appears on the display. ML-3051N,ML-3051ND only Open the front cover Pull the toner cartridge outItems Yield Average Maintenance partsClearing the Toner Low Replace Toner message Clearing paper jams TroubleshootingPaper feed area TrayMulti-purpose tray Optional trayPaper exit area Around the toner cartridgeDuplex jam Duplex unit area ML-3051NDonlyTips for avoiding paper jams Condition Suggested solutions Troubleshooting checklistUnderstanding the Status LED Status DescriptionUnderstanding display messages Toner cartridge-related messages Solving general printing problems Spool Settings button Settings and Printers. RightClick the Samsung ML-3050 Series PCL 6 printer iconSolving print quality problems Scatter Condition Suggested solutions BackMisformed CharactersCommon PostScript problems Common Windows problemsCommon Macintosh problems Common Linux problemsPrecautions when installing accessories Installing accessoriesInstalling a memory Dimm Disconnect the power cordSelect the Samsung ML-3050 Series PS printer Installing a wireless network interface cardSetting the memory in the PostScript printer properties Configuring basic network settings Configuring the wireless network parametersHexadecimal Alphanumeric Selecting the authentication typeSetting Encryption Printer specifications SpecificationsPrinter specifications Specifications and DescriptionIndex System requirements Linux 3.3 Macintosh 3.3 Windows Software section Contents Using Windows Postscript Driver Using Your Printer with a Macintosh Installing Software for Local Printing Installing Printer SoftwareTypical Installation Select Typical installation for a local printer. Click NextCustom Installation Select the components to be installed and click Next Select Custom installation. Click NextInstalling Software for Network Printing Custom Installation Installing Printer Software in Windows Select the components you want to reinstall and click Next Reinstalling Printer SoftwareNext Removing Printer SoftwareSelect your printer driver from the Name drop-down list Printing a DocumentPaper Orientation Printer SettingsLayout Tab Scaling Printing Paper TabSource Resolution Image ModeToner Save Mode Graphics TabPrinter Tab Extras TabAbout Tab Using Help Using a Favorite SettingPrinting Multiple Pages on One Sheet of Paper N-Up Printing Advanced PrintingPrinting Booklets Printing PostersPrinting a Reduced or Enlarged Document Printing on Both Sides of PaperFitting Your Document to a Selected Paper Size NoneUsing an Existing Watermark Using WatermarksCreating a Watermark Editing a WatermarkWhat is an Overlay? Using OverlaysUsing a Page Overlay Creating a New Page OverlayAdvanced Using Windows PostScript DriverSetting Up a Client Computer Setting Up a Host ComputerCheck the Share this printer box Select Local Port and click New PortPrinter Setting Troubleshooting GuideUnderstanding Smart Panel Toner LevelUsing Printer Settings Utility Opening the Troubleshooting GuideChanging the Smart Panel Program Settings Using Onscreen Help FileGetting Started Installing the Unified Linux DriverInstalling the Unified Linux Driver Uninstalling the Unified Linux Driver Using the Unified Driver ConfiguratorOpening the Unified Driver Configurator Click UninstallPorts Configuration Printers ConfigurationPrinters Tab Classes TabPrinting from Applications Configuring Printer PropertiesFollowing four tabs display at the top of the window Printing FilesInstall the Printer driver Installing printer driver for MacintoshUninstalling the Printer driver ML-3050 onlyFor a Network-connected Macintosh Setting Up the PrinterFor a USB-connected Macintosh Select Socket/HP Jet Direct in Printer TypeLayout Setting Changing Printer SettingsPrinting Printing a DocumentResolutionQuality Printer Features SettingPrinting Multiple Pages on One Sheet of Paper Reverse DuplexDuplex Printing Index Windows 15 toner save 15 true-type option Rev