Samsung ML-3051ND manual Installing a wireless network interface card

Page 57

6Push the DIMM straight into the DIMM slot until it snaps into place. Make sure the latches fit over the notches located on either side of the DIMM.

7Replace the control board cover.

8Reconnect the power cord and printer cable, and turn the printer on.

Setting the memory in the PostScript printer properties

After installing the memory DIMM, you need to select it in the printer properties of the PostScript printer driver so that you can use it.

1Make sure that the PostScript printer driver is installed in your computer. To installing the PostScript printer driver, you need to select Custom and put a check mark on the PostScript printer driver. See the Software Section.

2Click the Windows Start menu.

3For Windows 95/98/Me/NT4.0/2000, select Settings and then Printers.

For Windows XP/2003, select Printers and Faxes.

4Select the Samsung ML-3050 Series PS printer.

5Click the right mouse button on the printer icon and select Properties.

6For Windows 95/98/Me, select Device Option tab.

For Windows NT4.0/2000/XP/2003, select Device Settings tab.

7Select the amount of memory you installed from Printer Memory in the Installable Option section.

For Windows 98, select Installable Option → VMOption → change setting for:NMOption → change memory.

8Click OK.

Installing a wireless network interface card

The ML-3051N and ML-3051ND is equipped with a network interface which allows you to use your printer on a network. You can also purchase a wireless network interface card to enable the use of the printer in wireless network environments

To use the ML-3050 in network environments, you need to buy an optional wired or wireless network printer server. For information about installing the network printer server, see the network printer server user’s guide.

For order information, see page 7.1.

Review the precautions on page 10.1 and then follow this procedure to install the wireless network interface card in your printer.

1Turn the printer power off and unplug all cables from the printer.

2Grasp the control board cover and slide toward you to open it.

1

1 control board cover

10.2 <Installing accessories>

Image 57

Contents Page Page Contact Samsung worldwide Switzerland Contents Troubleshooting MaintenanceInstalling accessories SpecificationsImportant Precautions and Safety Information FCC Regulations FCC Statement for Wireless LAN useCanadian Radio Interference Regulations Federal Communications Commission FCCEuropean States qualified under wireless approvals Wireless GuidanceEuropean States with restrictions on use Replacing the Fitted Plug for UK Only Special features Printer overview Finding more information Special featuresIntroduction You can print in Windows 95/98/Me/NT 4.0/2000/XP/2003Features ML-3050 ML-3051N ML-3051ND Printer overviewFront view ML-3051N and ML-3051ND Rear view Control panel overviewFinding more information Using control panel menus ML-3051N,ML-3051NDonly System setupAccessing control panel menus Menu overviewLayout menu Information menuGraphic menu Paper menuEmulation menu System Setup menuPostScript Changing the display language ML-3051N,ML Printing a demoNetwork menu ML-3050, ML-3051NUsing toner save mode Changing the font settingUsing the control panel button From the software applicationSupplied software Software overviewFeature Printer driver featuresSystem requirements WindowsLinux MacintoshRequirements Configuring TCP/IP Network setupVia network administration programs Supported operating systemsConfiguring IPX frame types Configuring EtherTalkDynamic addressing BOOTP/DHCP Static addressingRestoring the network configuration Setting Ethernet speedPrinting a network configuration Using SetIP programSelecting print media Loading print mediaSupported sizes of paper Type Size Dimensions Weighta CapacitybGuidelines for selecting and storing print media Guidelines for special print mediaMedia type Guidelines Loading paper Changing the size of the paper in the tray Using the tray 1 or the optional trayLoad the paper with the side to be printed on facing up Using the multi-purpose trayTips on using the multi-purpose tray Using manual feed modeSelecting an output location Printing to the output tray Face downPrinting to the rear cover Face up Printing a document Canceling a print job Canceling a print jobBasic printing Printing a documentAccessories Ordering supplies and accessoriesHow to purchase Toner cartridgesCleaning the printer MaintenanceCleaning the outside of the printer Cleaning the inside of the printerChecking the remaining toner Maintaining the toner cartridgeReplacing the toner cartridge Redistributing toner cartridgeToner Low appears on the display. ML-3051N,ML-3051ND only Open the front cover Pull the toner cartridge outMaintenance parts Clearing the Toner Low Replace Toner messageItems Yield Average Clearing paper jams TroubleshootingPaper feed area TrayMulti-purpose tray Optional trayPaper exit area Around the toner cartridgeDuplex jam Duplex unit area ML-3051NDonlyTips for avoiding paper jams Condition Suggested solutions Troubleshooting checklistUnderstanding the Status LED Status DescriptionUnderstanding display messages Toner cartridge-related messages Solving general printing problems Spool Settings button Settings and Printers. RightClick the Samsung ML-3050 Series PCL 6 printer iconSolving print quality problems Scatter Condition Suggested solutions BackMisformed CharactersCommon PostScript problems Common Windows problemsCommon Macintosh problems Common Linux problemsPrecautions when installing accessories Installing accessoriesInstalling a memory Dimm Disconnect the power cordInstalling a wireless network interface card Setting the memory in the PostScript printer propertiesSelect the Samsung ML-3050 Series PS printer Configuring basic network settings Configuring the wireless network parametersSelecting the authentication type Setting EncryptionHexadecimal Alphanumeric Printer specifications SpecificationsPrinter specifications Specifications and DescriptionIndex System requirements Linux 3.3 Macintosh 3.3 Windows Software section Contents Using Windows Postscript Driver Using Your Printer with a Macintosh Installing Software for Local Printing Installing Printer SoftwareTypical Installation Select Typical installation for a local printer. Click NextCustom Installation Select the components to be installed and click Next Select Custom installation. Click NextInstalling Software for Network Printing Custom Installation Installing Printer Software in Windows Select the components you want to reinstall and click Next Reinstalling Printer SoftwareNext Removing Printer SoftwareSelect your printer driver from the Name drop-down list Printing a DocumentPrinter Settings Layout TabPaper Orientation Paper Tab SourceScaling Printing Resolution Image ModeToner Save Mode Graphics TabExtras Tab About TabPrinter Tab Using Help Using a Favorite SettingPrinting Multiple Pages on One Sheet of Paper N-Up Printing Advanced PrintingPrinting Booklets Printing PostersPrinting a Reduced or Enlarged Document Printing on Both Sides of PaperFitting Your Document to a Selected Paper Size NoneUsing an Existing Watermark Using WatermarksCreating a Watermark Editing a WatermarkWhat is an Overlay? Using OverlaysUsing a Page Overlay Creating a New Page OverlayAdvanced Using Windows PostScript DriverSetting Up a Client Computer Setting Up a Host ComputerCheck the Share this printer box Select Local Port and click New PortPrinter Setting Troubleshooting GuideUnderstanding Smart Panel Toner LevelUsing Printer Settings Utility Opening the Troubleshooting GuideChanging the Smart Panel Program Settings Using Onscreen Help FileInstalling the Unified Linux Driver Installing the Unified Linux DriverGetting Started Uninstalling the Unified Linux Driver Using the Unified Driver ConfiguratorOpening the Unified Driver Configurator Click UninstallPorts Configuration Printers ConfigurationPrinters Tab Classes TabPrinting from Applications Configuring Printer PropertiesFollowing four tabs display at the top of the window Printing FilesInstall the Printer driver Installing printer driver for MacintoshUninstalling the Printer driver ML-3050 onlyFor a Network-connected Macintosh Setting Up the PrinterFor a USB-connected Macintosh Select Socket/HP Jet Direct in Printer TypeLayout Setting Changing Printer SettingsPrinting Printing a DocumentResolutionQuality Printer Features SettingPrinting Multiple Pages on One Sheet of Paper Reverse DuplexDuplex Printing Index Windows 15 toner save 15 true-type option Rev