Samsung ML-3051ND manual Solving general printing problems

Solving general printing problems

For problems with the operation of your printer, refer to the table for suggested solutions.

Condition	Possible cause	Suggested solutions
	The printer is not	Check the power cord
		connections. Check the power
	receiving power.
		switch and the power source.
	The printer is not	Select Samsung ML-3050
		Series PCL 6 orSamsung ML-
	selected as the
		3050 Series PS as your default
	default printer.
		printer.
	The printer cover	Close the printer cover.
	is not closed.
	Paper is jammed.	Clear the paper jam. See
		page 9.1.
	No paper is	Load paper. See page 5.4.
	loaded.
	The toner	Install the toner cartridge.
	cartridge is not
	installed.
	The printer may	Check the display message,
The printer		add paper to the multi-purpose
	be in manual feed	tray, and press Stop (ML-3050)
does not
	mode and out of	or OK (ML-3051N or ML-
print.
	paper.	3051ND) on the printer’s
		control panel.
	The connection
	cable between
	the computer and	Disconnect the printer cable
	the printer is not	and reconnect it.
	connected
	properly.
	The connection	If possible, attach the cable to
	cable between	another computer that is
	the computer and	working properly and try to print
	the printer is	a document. You can also try
	defective.	using a different printer cable.
		Check the Windows printer
		setting to make sure that the
	The port setting is	print job is sent to the correct
		port. If the computer has more
	incorrect.
		than one port, make sure that
		the printer is attached to the
		correct one.

Condition	Possible cause	Suggested solutions
	The printer may	Check the printer properties to
	be configured	ensure that all of the print
	incorrectly.	settings are correct.
The printer	The printer driver	Reinstall the printer driver; See
	may be
does not		the Software Section. Try
	incorrectly
print.		printing a test page.
	installed.
(Continued)
	The printer is	Check the display message on
		the control panel to determine if
	malfunctioning.	the printer is indicating a
		system error.
Printer		For many software
		applications, the paper source
selects print	The paper source
		selection is found under the
materials	selection in the
		Paper tab within the printer
from the	printer properties
		properties. Select the correct
wrong paper	may be incorrect.
		paper source. See the
source.
		Software Section.
	Paper has not	Remove paper from the tray
		and reload it correctly.
	been loaded
		Check that the paper size
Paper does	correctly.
		guides are set correctly.
not feed into
	There is too much	Remove excess paper from the
the printer.
	paper in the tray.	tray.
	The paper is too	Use only paper that meets
	thick.	printer specifications.
		Reduce the complexity of the
		page(s) or try adjusting the
		print quality settings.
		To adjust the print quality
		settings, reduce the resolution.
		If you have set the resolution to
		1200 dpi (Best), change it to
		600 dpi (Normal). See the
Print job is	The job may be	Software Section.
		Change the port setting to the
extremely
	very complex.	USB or network port to improve
slow.
		print speed.
		Your printer prints A4-sized
		paper at 28 ppm and letter-
		sized paper at 30 ppm. If you
		use the ML-3051ND, your
		printer prints A4-sized paper at
		19 ipm and letter-sized paper at
		21 ipm in the duplex printing
		mode.

9.9 <Troubleshooting>