6Push the DIMM straight into the DIMM slot until it snaps into place. Make sure the latches fit over the notches located on either side of the DIMM.
7Replace the control board cover.
8Reconnect the power cord and printer cable, and turn the printer on.
Setting the memory in the PostScript printer properties
After installing the memory DIMM, you need to select it in the printer properties of the PostScript printer driver so that you can use it.
1Make sure that the PostScript printer driver is installed in your computer. To installing the PostScript printer driver, you need to select Custom and put a check mark on the PostScript printer driver. See the Software Section.
2Click the Windows Start menu.
3For Windows 2000, select Settings and then Printers. For Windows XP/2003, select Printers and Faxes.
For Windows Vista, select Control Panel
4Select the Samsung ML-3470 Series printer.
5Click the right mouse button on the printer icon and select Properties.
6For Windows 2000/XP/2003/Vista, select Device Settings tab.
7Select the amount of memory you installed from Printer Memory in the Installable Option section.
8Click OK.
Installing a wireless network interface card
For order information, see page 7.1.
Review the precautions on page 10.1 and then follow this procedure to install the wireless network interface card in your printer.
1Turn the printer power off and unplug all cables from the printer.
2Grasp the control board cover and slide toward you to open it.
1
1 control board cover
3Align the connector on the wireless network interface card with the connector on the control board. Push the card firmly into the connector on the control board until it is completely and securely in place.
1
2
1 | connector | |
2 | wireless network | |
interface card | ||
|
10.2 <Installing accessories>