Samsung ML-3470D manual Loading paper

Media type			Guidelines
	•	To avoid damaging the printer, use only
		transparencies designed for use in laser printers.
	•	Transparencies used in the printer must be able
		to withstand 200° C (392° F), the printer’s fusing
		temperature.
	• Place them on a flat surface after removing them
		from the printer.
Transparencies	•	Do not leave them in the paper tray for long
		periods of time. Dust and dirt may accumulate
		on them, resulting in spotty printing.
	•	To avoid smudging caused by fingerprints,
		handle them carefully.
	•	To avoid fading, do not expose printed
		transparencies to prolonged sunlight.
	•	Ensure that transparencies are not wrinkled,
		curled, or have any torn edges.
	•	To avoid damaging the printer, use only labels
		designed for use in laser printers.
	•	When selecting labels, consider the following
		factors:
		-	Adhesives: The adhesive material should be
			stable at 200° C (392° F), the printer’s fusing
			temperature.
		- Arrangement: Only use labels with no exposed
			backing between them. Labels can peel off
			sheets that have spaces between the labels,
			causing serious jams.
		-	Curl: Prior to printing, labels must lie flat with
			no more than 13 mm (5 inches) of curl in any
Labels			direction.
		-	Condition: Do not use labels with wrinkles,
			bubbles, or other indications of separation.
	•	Make sure that there is no exposed adhesive
		material between labels. Exposed areas can
		cause labels to peel off during printing, which
		can cause paper jams. Exposed adhesive can
		also cause damage to printer components.
	•	Do not run a sheet of labels through the printer
		more than once. The adhesive backing is
		designed for only a single pass through the
		printer.
	•	Do not use labels that are separating from the
		backing sheet or are wrinkled, bubbled, or
		otherwise damaged.
	•	Do not print on media smaller than 76 mm
Card stock or		(3 inches) wide or 127 mm (5 inches) long.
custom-sized	•	In the software application, set margins at least
materials		6.4 mm (0.25 inches) away from the edges of
		the material.

Media type		Guidelines
	•	Letterhead must be printed with heat-resistant
		ink that will not melt, vaporize, or release
		hazardous emissions when subjected to the
		printer’s fusing temperature of 205° C (400° F)
		for 0.1 second.
	•	Letterhead ink must be non-flammable and
Preprinted		should not adversely affect printer rollers.
paper	•	Forms and letterhead should be sealed in a
		moisture-proof wrapping to prevent changes
		during storage.
	•	Before you load preprinted paper, such as forms
		and letterhead, verify that the ink on the paper is
		dry. During the fusing process, wet ink can come
		off preprinted paper, reducing print quality.

Loading paper

Load the print media you use for the majority of your print jobs in the tray 1. The tray 1 can hold a maximum of 250 sheets of 21 lb plain paper.

You can purchase an optional tray (tray 2) and attach it below the standard tray to load an additional 250 sheets of paper. For order information for an optional tray, see page 7.1.

The paper level indicator on the front of the tray 1 and the optional tray 2 shows the amount of paper currently left in the tray. When the tray is empty, the indicator bar appears at the bottom.

Full Empty

5.4 <Loading print media>